Iskanje po repozitoriju

A+ | A- | | SLO | ENG

Povzetek: Geotechnical structures in rock masses such as tunnels, underground caverns, dam foundations and rock slopes often have problems with a jointed rock mass. The shear behaviour of a jointed rock mass depends on the mechanical behaviour of the discontinuities in that particular rock mass. If we want to understand the mechanical behaviour of a jointed rock mass, it is necessary to study the deformation and strength of a single joint. One of the primary objectives of this work is to improve the understanding of the frictional behaviour of rough rock joints under shear loads with regard to the roughness of the joint surface. The main problem is how to measure and quantify the roughness of the surface joint and connect the morphological parameters into a shear strength criterion. Until now, several criteria have been developed; however, all of them used large rock samples (20×10×10 cm). It is often not possible to get large samples, especially when the rock is under a few meters thick layer of soil. In this case, samples of rock can only be acquired with investigation borehole drilling, which means that the samples of rock are small and of different shapes. The paper presents the modified criterion that is suitable for calculating the peak shear stress of small samples.
Ključne besede: camera-type 3D scanner, rock mechanics rock joint, roughness of the joints, rock joint shear strength
Objavljeno v DiRROS: 11.12.2023; Ogledov: 189; Prenosov: 85
Celotno besedilo (847,17 KB)
Gradivo ima več datotek! Več...