Iskanje po repozitoriju

A+ | A- | | SLO | ENG

Povzetek: Al(OH)3 nanoparticles (ATH NPs) and phosphorylated cellulose nanofibrils (PCNFs) were used as user-friendly and comfortable coating components on flame-retardant fabric to improve its thermophysiological comfort and high-intensive heat protection properties. The effect of the PCNF imprinting and its attachment after the post-printing of a hydrophobic polyacrylate (AP) on the same (back side) or the other (front) side of the fabric, with and without the addition of ATH NPs, was considered, to maintain the front side (facing the wearer) as hydrophilic while keeping the back side (facing the outside) hydrophobic. The amount of coatings applied and their patterning were studied, varied with the ATH NPs’ concentration (1.7, 3.3 and 6.7 wt%) and screen mesh size used (60 and 135), based on the coating’ mass, fabric’s air permeability, thickness and microstructure. The reduced moisture build-up (55%), increased the water vapour (13%) and heat (12%) transfer from the skin, were assessed by applying PCNF under the AP, being more pronounced in the case of using a 135 mesh-sized screen, given the smaller, more densely distributed, thinner and imprinted pattern coatings. These effects were further improved by the addition of nanoporous ATH NPs, which allowed more homogeneous spreading of the moisture and its faster transport. Such a treatment also shifted the fabric’s degradation temperature towards higher values (up to 15°C), retained up to 30% of high-heat flux (21 kW/m2), prolonged the time to ignition by 11 s and reduced the total heat released by up to 60%, thereby providing better protection when exposed to the heat, due to the presence of the phosphorous (PCNF) promoted generation of an Al2O3 char acting as a barrier layer, while also reducing the production of heat and generation of smoke by 75%.
Ključne besede: flame-retardant textile, Al(OH)3 nanoparticles, phosphorylated cellulose nanofibrils, screen-printing, thermophysiological comfort, heat protection
Objavljeno v DiRROS: 28.04.2023; Ogledov: 452; Prenosov: 128
Celotno besedilo (2,91 MB)
Gradivo ima več datotek! Več...

Povzetek: The complete mitochondrial genome of the Carniolan honeybee (Apis mellifera carnica) from Slovenia, a homeland of this subspecies, was acquired in two contigs from WGS data and annotated. The newly obtained mitochondrial genome is a circular closed loop of 16,447 bp. It comprises 37 genes (13 protein coding genes, 22 tRNA genes, and 2 rRNA genes) and an AT-rich control region. The order of the tRNA genes resembles the order characteristic of A. mellifera. The mitogenomic sequence of A. m. carnica from Slovenia contains 44 uniquely coded sites in comparison to the closely related subspecies A. m. ligustica and to A. m. carnica from Austria. Furthermore, 24 differences were recognised in comparison between A. m. carnica and A. m. ligustica subspecies. Among them, there are three SNPs that affect translation in the nd2, nd4, and cox2 genes, respectively. The phylogenetic placement of A. m. carnica from Slovenia within C lineage deviates from the expected position and changes the perspective on relationship between C and O lineages. The results of this study represent a valuable addition to the information available in the phylogenomic studies of A. mellifera—a pollinator species of worldwide importance. Such genomic information is essential for this local subspecies’ conservation and preservation as well as its breeding and selection.
Ključne besede: western honeybee, Apis mellifera carnica, mitochondrial genome, phylogeny, C lineage, annotation, whole genome sequencing, protection, conservation
Objavljeno v DiRROS: 06.09.2022; Ogledov: 541; Prenosov: 189
Celotno besedilo (1,06 MB)

Ključne besede: Poplar, Willow, Black Walnut, Black Locust, international commission, FAO, national report, questionnaire, genetics, forest protection, legislation, categorisation, forest products, ecology, Slovenia
Objavljeno v DiRROS: 11.12.2020; Ogledov: 1391; Prenosov: 420
Celotno besedilo (624,71 KB)

Povzetek: Worldwide, mountain forests represent a significant factor in reducing rockfall risk over long periods of time on large potential disposition areas. While the economic value of technical protection measures against rockfall can be clearly determined and their benefits indicated, there is no general consensus on the quantification of the protective effect of forests. Experience shows that wherever there is forest, the implementation of technical measures to reduce risk of rockfall might often be dispensable or cheaper, and large deforestations (e.g. after windthrows, forest fires, clear-cuts) often show an increased incidence of rockfall events. This study focussed on how the protective effect of a forest against rockfall can be quantified on an alpine transregional scale. We therefore estimated the runout length, in terms of the angle of reach, of 700 individual rockfall trajectories from 39 release areas from Austria, Germany, Italy and Slovenia. All recorded rockfall events passed through forests which were classified either as coppice forests or, according to the CORINE classification of land cover, as mixed, coniferous or broadleaved dominated high forest stands. For each individual rockfall trajectory, we measured the forest structural parameters stem number, basal area, top height, ratio of shrub to high forest and share of coniferous trees. To quantify the protective effect of forests on rockfall, a hazard reduction factor is introduced, defined as the ratio between an expected angle of reach without forest and the back-calculated forest-influenced angles of reach. The results show that forests significantly reduce the runout length of rockfall. The highest reduction was observed for mixed high forest stands, while the lowest hazard reduction was observed for high forest stands dominated either by coniferous or broadleaved tree species. This implies that as soon as one tree species dominates, the risk reduction factor becomes lower. Coppice forests showed the lowest variability in hazard reduction. Hazard reduction due to forests increases, on average, by 7% for an increase in the stem number by 100 stems per hectare. The proposed concept allows a global view of the effectiveness of protective forests against rockfall processes and thus enable to value forest ecosystem services for future transregional assessments on a European level. Based on our results, general cost%benefit considerations of nature-based solutions against rockfall, such as protective forests as well as first-order evaluations of rockfall hazard reduction effects of silvicultural measures within the different forest types, can be supported.
Ključne besede: protection forests, rockfall, European Alps, rockfall hazard
Objavljeno v DiRROS: 13.07.2020; Ogledov: 1619; Prenosov: 955
Celotno besedilo (2,03 MB)
Gradivo ima več datotek! Več...

Povzetek: In repressive protection of cultural/historical woodwork, microwaves have many advantages over conventional heating. The research%s objective was to examine conditions for eradication of house longhorn beetle larvae (Hylotrupes bajulus) in spruce wood (Picea abies) using microwaves. Larvae, inserted at different depths of spruce blocks containing 12% and 42% of moisture, were exposed to microwaves. Two apparatuses were used; a 750W commercial microwave chamber and a newly developed horn antenna microwave device with the power of 800W and a frequency of 2.45GHz, for targeted radiation. We discovered that the inner part of wood warmed up quicker than the surface heated to 65°C. For successful suppression larvae in the wood need to be heated to 54.5°C, for 10 seconds. The necessary exposure time increases with increasing thickness of wood. The surface of wood containing more moisture is heated quicker, but increased moisture slows down the penetration of microwaves into the wood specimen. Therefore, larvae in wood of lower moisture (12%) died faster, both those 20mm under surface (1.5min) and those at 130 mm of depth (10.5min).
Ključne besede: wooden objects, repressive wood protection, microwaves, heating, wood moisture content, house longhorn beetle, Hylotrupes bajulus
Objavljeno v DiRROS: 25.10.2017; Ogledov: 4950; Prenosov: 2892
Celotno besedilo (1,52 MB)
Gradivo ima več datotek! Več...