Digitalni repozitorij raziskovalnih organizacij Slovenije

Iskanje po repozitoriju
A+ | A- | Pomoč | SLO | ENG

Iskalni niz: išči po
išči po
išči po
išči po

Možnosti:
  Ponastavi


Iskalni niz: "avtor" (Rongxue Kang) .

1 - 2 / 2
Na začetekNa prejšnjo stran1Na naslednjo stranNa konec
1.
Thin-layer boilover of large-scale diesel pool fires at sub-atmospheric pressure
Jinlong Zhao, Qingyuan Zhang, Zhenqi Hu, Rongxue Kang, Grunde Jomaas, Rui Yang, 2024, izvirni znanstveni članek

Povzetek: As thin-layer burning of fuels on water are often followed by thin-layer boilover fires, particularly during the firefighting process, an experimental and numerical study was undertaken to address key aspects of such fires, especially in plateau areas (i.e., sub-atmospheric pressure). In the thin-layer boilover experiments at sub-atmospheric pressure (69 kPa), diesel was used as the fuel in five circular steel trays (ranging from 0.4 m to 1.2 m in diameter) and a square steel tray (side length of 2.5 m). The burning process, and especially the continuous boilover stage, was presented and the corresponding boilover intensity, time to boilover onset and boilover time interval were measured and analyzed. The results show that the flame height increased sharply at the initial boilover, while this increasing range gradually became weak for the subsequent boilovers. The initial boilover intensity showed a linear dependency on the fuel layer thickness at the time of boilover, and the slope of the boilover intensity line decreased with increasing pan area. Eventually, the effect of pan area on boilover intensity became limit. Moreover, a predictive model for the boilover intensity was established based on dimensionless analysis. The initial boilover onset time under the sub-atmospheric pressure was delayed compared with that under atmospheric pressure. The corresponding predictive correlation (for 69 kPa) with different diameter and fuel thickness was developed based on the one-dimension two-layer conduction model. In the end, the boilover time interval decreased with the boilover times, closing to uninterrupted boilover eventually. This work enriches the thin-layer boilover behavior experimental data at sub-atmospheric pressure and provides guidance for the fuel storage safety.
Ključne besede: thin-layer boilover, boilover intensity, time to boilover onset, boilover time interval, sub-atmospheric fires
Objavljeno v DiRROS: 16.01.2024; Ogledov: 177; Prenosov: 39
.pdf Celotno besedilo (1,04 MB)
Gradivo ima več datotek! Več...

2.
Experimental study of the burning behavior and key parameters of gasoline pool fires with different ullage heights
Jinlong Zhao, Xinjiang Li, Zhenqi Hu, Rongxue Kang, Grunde Jomaas, 2023, izvirni znanstveni članek

Povzetek: Pool fires with different ullage heights are a common type of fire accident. A series of gasoline pool fire ex- periments with two sizes (D = 40 cm, 60 cm) and six ullage heights (h = 0, 0.2D, 0.4D, 0.6D, 0.8D, 1.0D) are conducted. The burning process, axial temperature profile, radiative heat feedback, and burning rate are measured and analyzed. The result shows that the fuel vapor layer and the down-reaching flame layer are distinguished based on the axial temperature profile for the steady burning stage. Meanwhile, the down-reaching flame length (Ldown) increases more profoundly for large tank diameters under the same ullage height. Subse- quently, the dimensionless down-reaching flame length (Ldown* = Ldown/D) increases exponentially with the dimensionless ullage heights (h* = h/D). Finally, based on the classical burning rate model for the low ullage height and the heat transfer process from the flame to the fuel surface, a correlation with different ullage heights is established to calculate the burning rate, which is then validated against the experimental data in the paper and literature values. The results are of importance to understand the burning rate and the radiative heat feedback to the fuel surface for pool fires with different ullage heights.
Ključne besede: pool fires, ullage height, down-reaching flame, flame radiative heat feedback, burning rate correlation
Objavljeno v DiRROS: 08.01.2024; Ogledov: 173; Prenosov: 38
.pdf Celotno besedilo (1,51 MB)
Gradivo ima več datotek! Več...

Iskanje izvedeno v 0.07 sek.
Na vrh