1. Experimental and numerical investigation of restrained shrinkage of concreteLucija Hanžič, Jurij Karlovšek, Tomaž Hozjan, Sabina Huč, Zhongyu Xu, Igor Planinc, Johnny Ching Ming Ho, 2020, objavljeni znanstveni prispevek na konferenci Povzetek: To promote the understanding of shrinkage related behaviour of concrete used for tunnel linings the experimental and theoretical investigation including numerical and analytical approach was performed on ring-shaped specimens. Overall one analytical (an.) and two numerical models, namely (i) and (ii) were also developed. Models (an.) and (i) considered the restraining steel ring to be rigid, thus not exhibiting any deformation. Numerical model (ii) considered the steel ring to be deformable. The experimental set-up consisted of a large concrete ring with an inner diameter of 120 cm, an outer diameter of 160cm and 20 cm in height. The restraining steel ring was 5.5 cm thick. Two concrete rings were made, namely R1 with a low compressive strength of ~26MPa and the other, R2, with medium compressive strength of ~40 MPa. The strain was measured in the hoop direction on the inner circumference of the steel ring and on the outer circumference of the concrete ring. Concrete rings were subjected to circumferential drying. Numerical model (ii) predicted critical time to the formation of the first crack to be between 13 and 14 days. The experimentally determined critical time is found to be 11 to 13 days with cracks gradually opening over several days. This was indicated by changes in measured concrete and steel strain. Modelled concrete strain just before cracking was between -20 and -30 % 10-6 m m-1 however, measured concrete strain was ~150 % 10-6 m m-1. Modelled steel strain was between -30 and -40 % 10-6 m m-1 while measured steel strain was between -10 and 20 % 10-6 m m-1. These discrepancies, in particular the positive steel strain obtained in experiments, require further investigation and improvements of the experimental set-up. Ključne besede: concrete, tunnel lining, restrained shrinkage, Reissner beam theory, modelling Objavljeno v DiRROS: 19.01.2024; Ogledov: 189; Prenosov: 78 Celotno besedilo (18,89 MB) Gradivo ima več datotek! Več... |
2. Structural and elastic properties of AgNi[sub]10 alloy studied with ab-initio calculationsJide Liu, Xue Wang, Xiaoming Du, Ming Xie Xie, Jinguo Li, Shangqiang Zhao, Yizhou Zhou, Qiao Zhang, Jiheng Fang, 2022, izvirni znanstveni članek Ključne besede: AgNi[sub]10 alloy, ab initio calculations, elastic anisotropy, thermodynamic properties Objavljeno v DiRROS: 22.06.2022; Ogledov: 553; Prenosov: 139 Povezava na datoteko |
3. |
4. Effect of CeO[sub]2 doping on the microstructure and corrosion behavior of CoCuNiTi high-entropy alloy coatingsMing-xing Ma, Liang Zhao, Zhi-xin Wang, Shang-zhi Li, Chen Dong, 2021, izvirni znanstveni članek Ključne besede: high-entropy alloy coating, CoCuNiTi, microstructure, corrosion behavior, laser cladding Objavljeno v DiRROS: 06.05.2022; Ogledov: 511; Prenosov: 118 Povezava na datoteko |