Iskanje po repozitoriju

A+ | A- | | SLO | ENG

Povzetek: The dataset supports the data presented in the tables and figures of the scientific article Sequestration capacity of bio-based ashes and influence of carbonation on the leaching behavior depending on their mineralogical composition (doi: 10.1016/j.ceramint.2025.11.229). It includes calcimetric measurements, XRF, TGA, and XRD analysis data, as well as calculations of CO2 uptake and CO2 sequestration capacity for the analyzed samples. Additionally, it contains original FTIR measurement data, which are not included in the article and serve as supplementary material.
Ključne besede: enforced carbonation, maximum sequestration capacity, leaching, heavy metals, mineralogy, bio-based ash
Objavljeno v DiRROS: 21.10.2025; Ogledov: 147; Prenosov: 52
Raziskovalni podatki (1,56 MB)
Gradivo ima več datotek! Več...

Povzetek: Although magnesium is one of the most abundant elements on Earth by weight, the demand for magnesium is constantly increasing due to its widespread use in a diverse range of industries such as metal alloys, electronics, batteries, agricultural and pharmaceutical compounds. For this reason, magnesium is categorised as a critical raw material by the European Union. Dolomite CaMg(CO3)2 is one of the most important mineral sources of magnesium, which in its pure form contains 13.18 % magnesium by weight. Various pyrometallurgical and hydrometallurgical processes have been developed and are used to extract magnesium from dolomite and other magnesium ores. In this study, samples of dolomite of different geological ages were collected in Slovenia and their elemental composition was analysed by microwave-assisted acid digestion and ICP-OES. Magnesium was then extracted by selective leaching and selective precipitation. Leaching was carried out with inorganic and organic acids. The separation of magnesium and calcium in a solution prepared by dissolving dolomite with acid was carried out by precipitation with hydroxide and oxalate. High extraction yields of magnesium and a significant separation between the two metals were achieved with both methods.
Ključne besede: magnesium, dolomite, extraction, selective leaching, selective precipitation
Objavljeno v DiRROS: 16.07.2025; Ogledov: 435; Prenosov: 252
Celotno besedilo (985,91 KB)
Gradivo ima več datotek! Več...

Povzetek: Alkali-activated foams (AAFs) are inorganic porous materials that can be obtained at temperatures well below 100° C with the use of inorganic wastes as aluminosilicate precursors. In this case, fly ash derived from a Slovenian power plant has been investigated. Despite the environmental benefits per se, due to saving of energy and virgin materials, when using waste materials, it is of extreme importance to also evaluate the potential leaching of heavy metal cations from the alkali-activated foams. This article presents an environmental study of a porous geopolymer derived from this particular fly ash, with respect to the leachability of potentially hazardous elements, its environmental toxicity as determined by biological testing, and the environmental impact of its production. In particular, attention was focused to investigate whether or not 1,000 °C-fired alkali- activated fly ash and metakaolin-based foams, cured at 70 °C, are environmentally friendlier options compared to unfired ones, and attempts to explain the rationale of the results were done. Eventually, the firing process at 1,000 ° C, apart from improving technical performance, could reinforce heavy metal cation entrapment within the aluminosilicate matrix. Since technical performance was also modified by addition of different types of activators (K-based or Na-based), as well as by partial replacement of fly ash with metakaolin, a life cycle assessment (LCA) analysis was performed to quantify the effect of these additions and processes (curing at 70 ° C and firing at 1,000 °C) in terms of global warming potential. Selected samples were also evaluated in terms of leaching of potentially deleterious elements as well as for the immobilization effect of firing. The leaching test indicated that none of the alkali-activated material is classified as hazardous, not even the as-received fly ash as component of new AAF. All of the alkali-activated foams do meet the requirements for an inertness. The highest impact on bacterial colonies was found in samples that did not undergo firing procedures, i.e., those that were cured at 70 °C, which induced the reduction of bacterial Enterococcus faecalis viability. The second family of bacteria tested, Escherichia coli, appeared more resistant to the alkaline environment (pH = 10–12) generated by the unfired AAMs. Cell viability recorded the lowest value for unfired alkali-activated materials produced from fly ash and K-based activators. Its reticulation is only partial, with the leachate solution appearing to be characterized with the most alkaline pH and with the highest ionic conductivity, i.e., highest number of soluble ions. By LCA, it has been shown that 1) changing K-based activators to Na-based activators increases environmental impact of the alkali-activated foams by 1%–4% in terms of most of the impact categories (taking into account the production stage). However, in terms of impact on abiotic depletion of elements and impact on ozone layer depletion, the increase is relatively more significant (11% and 18%, respectively); 2) replacing some parts of fly ash with metakaolin also results in relatively higher environmental footprint (increase of around 1%–4%, while the impact on abiotic depletion of elements increases by 14%); and finally, 3) firing at 1,000°C contributes significantly to the environmental footprint of alkali- activated foams. In such a case, the footprint increases by around one third, compared to the footprint of alkali-activated foams produced at 70 ° C. A combination of LCA and leaching/toxicity behavior analysis presents relevant combinations, which can provide information about long-term environmental impact of newly developed waste-based materials.
Ključne besede: alkali activated materials, geopolimers, leaching, LCA
Objavljeno v DiRROS: 20.06.2023; Ogledov: 7431; Prenosov: 733
Celotno besedilo (3,42 MB)
Gradivo ima več datotek! Več...

Povzetek: Alkali-activated materials (AAMs) represent a promising alternative to conventional building materials and ceramics. Being produced in large amounts as aluminosilicate-rich secondary products, such as slags, they can be utilized for the formulation of AAMs. Slags are partially crystalline metallurgical residues produced during the high temperature separation of metallic and non-metallic materials in the steelmaking processes. In the present study, the electric arc furnace carbon or stainless steel slag (EAF) and secondary metallurgical slag such as ladle furnace basic slag (LS) were used as precursors in an alkali-activation process. EAF slag, with its amorphous fraction of about 56%, presented higher contents of soluble Si and Al species with respect to ladle slag R (35%). However, both are suitable to produce AAM. The leaching behavior shows that all the release values are below the regulation limit. All the bivalent ions (Ba, Cd, Cu, Ni, Pb, and Zn) are well immobilized in a geopolymeric matrix, while amphoteric elements, such as As and Cr, show a slight increase of release with respect to the corresponding slag in alkaline and aqueous environments. In particular, for Sb and As of AAM, release still remains below the regulation limits, while Mo presents an increase of leaching values that slightly exceeds the limit for landfill non-dangerous waste.
Ključne besede: slag, aluminosilicate materials, chemical reactivity, cold consolidation, alkali activation, leaching test, open access
Objavljeno v DiRROS: 22.05.2023; Ogledov: 1852; Prenosov: 744
Celotno besedilo (4,49 MB)
Gradivo ima več datotek! Več...

Povzetek: Old metallurgical dumps across Europe represent a loss of valuable land and a potential threat to the environment, especially to groundwater (GW). The Javornik electric arc furnace (EAF) and ladle slag heap, situated in Slovenia, was investigated in this study. The environmental impact of the slag heap was evaluated by combining leaching characterization tests of landfill samples and geochemical modelling. It was shown that throughout the landfill the same minerals and sorptive phases control the leaching of elements of potential concern, despite variations in chemical composi- tion. Although carbonation of the disposed steel slags occurred (molar ratio CO3/(Ca+Mg) = 0.53) relative to fresh slag, it had a limited effect on the leaching behaviour of elements of potential concern. The leaching from the slag heaps had also a limited effect on the quality of the GW. A site-specific case, however, was that leachates from the slag heap were strongly diluted, since a rapid flow of GW fed from the nearby Sava River was observed in the landfill area. The sampling and testing approach applied provides a basis for assessing the long-term impact of release and is a good starting point for evaluating future management options, including beneficial uses for this type of slag.
Ključne besede: EAF slag, field verification, geochemical modelling, ladle slag, leaching, release prediction, steel slag heap
Objavljeno v DiRROS: 28.04.2023; Ogledov: 1741; Prenosov: 832
Celotno besedilo (4,37 MB)
Gradivo ima več datotek! Več...