1. Experimental carbonation study for durability assessment of novel cementitious materialsSebastijan Robič, Aljoša Šajna, Lucija Hanžič, Alisa Machner, Marie Helene Bjørndal, Klaartje De Weerdt, Yushan Gu, Benoit Bary, Rosamaria Lample, 2021, objavljeni znanstveni prispevek na konferenci Povzetek: The design process of concrete structures is carried out using standards and guidelines, while the durability predictions of concrete structures is supported only with exposure classes and experience-based requirements. To improve durability predictions of the carbonation resistance of concrete, a numerical model is being developed within the Horizon 2020 project EnDurCrete, coupling the rate of carbonation, and the drying rate. To verify the numerical model, an accelerated carbonation study was carried out. Experiments were conducted on mortars incorporating a novel CEM II/C (S-LL) cement, developed within the EnDurCrete project, and a commercially available reference cementCEM II/A-S. EnDurCrete mortars (EnM) and reference mortars (RefM) were prepared with water-cement ratios of 0.6 and 0.5 (denoted with label extensions -06 and -05). Visual assessments and thermogravimetric analysis (TGA) were used to measure the carbonation rates, which were found to be ~1.0 mm day-0.5 in EnM-06 and ~0.6 mm day-0.5 in RefM-06, while in EnM-05 and RefM-05 the values were ~0.7 and ~0.2 mm day-0.5 respectively. Additionally, TGA shows that the initial portlandite (CH) content is ~1.5 wt% in EnM-06 as opposed to ~3.0 wt% in RefM-06. The difference in the initial CH content in the two hydrated binders might explain the difference in their carbonation rate. During the moisture transport experiments a gravimetric method was used to determine mass changes as specimens underwent drying and resaturation with and without CO2 present. The drying led to a decrease in mass, but in the presence of CO2 this mass loss was compensated by the mass gain due to uptake of CO2 during carbonation. The resaturation experiments indicate an increase in the suction porosity in the carbonated samples compared to the non-carbonated samples. Ključne besede: concrete, absorption of water, carbonation, durability assessment, model verification Objavljeno v DiRROS: 25.01.2024; Ogledov: 400; Prenosov: 275
Celotno besedilo (9,29 MB) Gradivo ima več datotek! Več... |
2. Measurement of the chloride resistance of environmentally friendly and durable concreteAlisa Machner, Marie Helene Bjørndal, Aljoša Šajna, Lucija Hanžič, Yushan Gu, Benoit Bary, Klaartje De Weerdt, 2020, objavljeni znanstveni prispevek na konferenci Povzetek: The increasing demand for concrete and thereby Portland cement, creates the need for novel low-clinker Portland composite cements. Concretes prepared with such novel composite cements need to show similar or even improved durability compared to concrete prepared with commonly used Portland composite cements. This study represents a part of the EnDurCrete project that focuses on the durability of concrete produced with novel low-clinker cements, containing high-value industrial by-products. More specifically, we investigated the chloride ingress resistance of such concrete. Concrete cylinders were submitted to chloride ingress by bulk diffusion. The chloride ingress resistance was investigated on concrete samples by %XRF scanning and chloride titration. In addition, the chloride binding capacity of these novel binders was investigated on paste samples by determining chloride binding isotherms for both binders. In the next step of the project, these experimental results will be matched with an advanced model, which is being developed within the project. By combining modelling with experimental verification, we aim to reach a better understanding of the fundamental chloride ingress mechanisms acting on novel types of concrete. The overall goal of the work is to produce a concrete with lower cost, lower environmental footprint and with verified similar or improved durability. Ključne besede: chloride ingress, durability, novel binders, Low C02, sustainability, concrete Objavljeno v DiRROS: 19.01.2024; Ogledov: 442; Prenosov: 191
Celotno besedilo (18,89 MB) Gradivo ima več datotek! Več... |
3. Experimental carbonation study for a durability assessment of novel cementitious materialsLucija Hanžič, Sebastijan Robič, Alisa Machner, Marie Helene Bjørndal, Klaartje De Weerdt, Yushan Gu, Benoit Bary, Rosa Maria Lample Carreras, Aljoša Šajna, 2021, izvirni znanstveni članek Povzetek: Durability predictions of concrete structures are derived from experience-based require- ments and descriptive exposure classes. To support durability predictions, a numerical model related to the carbonation resistance of concrete was developed. The model couples the rate of carbonation with the drying rate. This paper presents the accelerated carbonation and moisture transport exper- iments performed to calibrate and verify the numerical model. They were conducted on mortars with a water-cement ratio of either 0.6 or 0.5, incorporating either a novel cement CEM II/C (S-LL) (EnM group) or commercially available CEM II/A-S cement (RefM group). The carbonation rate was determined by visual assessment and thermogravimetric analysis (TGA). Moisture transport experi- ments, consisting of drying and resaturation, utilized the gravimetric method. Higher carbonation rates expressed in mm/day−0.5 were found in the EnM group than in the RefM group. However, the TGA showed that the initial portlandite (CH) content was lower in the EnM than in the RefM, which could explain the difference in carbonation rates. The resaturation experiments indicate an increase in the suction porosity in the carbonated specimens compared to the non-carbonated specimens. The study concludes that low clinker content causes lower resistance to carbonation, since less CH is available in the surface layers; thus, the carbonation front progresses more rapidly towards the core. Ključne besede: mortar, absorption of water, carbonation, durability assessment, model verification Objavljeno v DiRROS: 05.07.2023; Ogledov: 484; Prenosov: 278
Celotno besedilo (4,84 MB) Gradivo ima več datotek! Več... |
4. Impact of leaching on chloride ingress profiles in concreteAlisa Machner, Marie Helene Bjørndal, Aljoša Šajna, Nikola Mikanovic, Klaartje De Weerdt, 2022, izvirni znanstveni članek Povzetek: To investigate the effect of leaching on chloride ingress profiles in concrete and mortar, we exposed concrete and mortar specimens for 90 and 180 days to two different exposure solutions: 3% NaCl, and 3% NaCl with KOH added to limit leaching. The solutions were replaced weekly. After exposure, we determined total chloride profiles to investigate the chloride ingress, and portlandite profiles to assess the extent of leaching. The results showed that leaching during exposure greatly affects the chloride ingress profiles in mortar and concrete. We found that leaching leads to considerably higher maximum total chloride content and deeper chloride penetration into the concrete than in the specimens where leaching was limited. We recommend therefore that leaching should be taken into account in standard laboratory testing and that more mechanistic service life models should be used to take into account the impact of leaching. Ključne besede: chloride ingress, service life prediction, leaching, concrete, portlandite, open access Objavljeno v DiRROS: 04.05.2023; Ogledov: 459; Prenosov: 314
Celotno besedilo (1,17 MB) Gradivo ima več datotek! Več... |
5. Effect of leaching on the composition of hydration phases during chloride exposure of mortarAlisa Machner, Marie Helene Bjørndal, Harald Justnes, Lucija Hanžič, Aljoša Šajna, Yushan Gu, Benoit Bary, Mohsen Ben Haha, Mette R. Geiker, Klaartje De Weerdt, 2022, izvirni znanstveni članek Povzetek: Mortar specimens were exposed to either a 3% NaCl solution or a 3% NaCl+KOH solution for up to 180 days. Exposure to the NaCl solution provoked much more leaching than the NaCl+KOH exposure. Leaching strongly impacted the chloride ingress profiles. The extended leaching led to a maximum total chloride content almost three times higher and a deeper chloride penetration than exposure with limited leaching after 180 days. The higher maximum chloride content seems to be linked to the enhanced binding capacity of the C-S-H and AFm phases upon moderate leaching as determined by SEM-EDS. The total chloride profile appears to be governed by multi-ion transport and the interaction of chloride with the hydration phases. Service life prediction and performance testing both rely on total chloride profiles and therefore ought to take these interactions into account. Ključne besede: chloride binding, Friedel's salt, Kuzel's salt, ph, GEMS, thermodynamic modelling, open access Objavljeno v DiRROS: 26.04.2023; Ogledov: 508; Prenosov: 419
Celotno besedilo (7,13 MB) Gradivo ima več datotek! Več... |