1. Exploring the mesoscale connectivity of phytoplankton periodic assemblages' succession in northern Adriatic pelagic habitatsIvano Vascotto, Fabrizio Bernardi Aubry, Mauro Bastianini, Patricija Mozetič, Stefania Finotto, Janja Francé, 2024, izvirni znanstveni članek Povzetek: An appropriate model for phytoplankton distribution patterns is critical for understanding biogeochemical cycles and trophic interactions in the oceans and seas. Because phytoplankton dynamics in coastal waters are more complex due to shallow depth and proximity to land, more accurate models applied to the correct spatial and temporal scales are needed. Our study investigates the role of the atmosphere and hydrosphere in pelagic habitat by modelling phytoplankton assemblages at two Long Term Ecological Research sites in the northern Adriatic Sea using niche-forming environmental variables (wind, temperature, salinity, river discharge, rain, and water column stratification). To study the synchronization between the phytoplankton community and these environmental variables at the two LTER sites, we applied current linear and nonlinear numerical methods for ecological modelling. The aim was to use periodic and/or non-periodic properties of the environmental variables to classify the phytoplankton assemblages at one LTER site (Gulf of Trieste - Slovenia) and then predict them at another LTER site 100 km away (Gulf of Venice - Italy). We found that periodicity played a role in the explanatory and predictive power of the environmental variables and that it was more important than non-periodic events in defining the common structure of the two pelagic habitats. The non-linear classification functions of the neural networks further increased the predictive power of these variables. We observed partial synchronization of communities at the mesoscale and differences between the original and predicted assemblages under similar environmental conditions. We conclude that mesoscale connectivity plays an important role in phytoplankton communities in the northern Adriatic. However, the loss of periodicity of niche-forming variables due to more frequent extreme meteorological and hydrological events could loosen these connections and affect the temporal succession of phytoplankton assemblages. Ključne besede: phytoplankton, assemblages, Northern Adriatic, phenology, marine biology, hydrobiology Objavljeno v DiRROS: 16.05.2024; Ogledov: 258; Prenosov: 294
Celotno besedilo (6,94 MB) Gradivo ima več datotek! Več... |
2. Innovative pre-fabricated components including different waste construction materials reducing building energy and minimising environmental impacts (InnoWEE)Elena Loredana Fodor, Vilma Ducman, Giovanni Ferrarini, Sergio Tamburini, Constantinos Tsoutis, Francesca Becherini, Antonio Garrido-Marijuán,, Giulia Mezzasalma, Leonardo Rossi, Emil Lezak, Adriana Bernardi, 2019, objavljeni znanstveni prispevek na konferenci Povzetek: InnoWEE is a four-year project (from 2016 to 2020) financed by the European Community that involves ten partners from different European countries, as Greece, Italy, Belgium, Romania, Slovenia, Spain and Poland. The aim is to use the waste materials coming from construction and demolition processes of buildings and include them into a geopolymeric matrix with the purpose of producing prefabricated panels for different applications. Construction and demolition waste (CDW) materials with suitable characteristics have been selected to develop high performance geopolymeric panels for building walls envelopes and radiant panels for indoor walls and ceilings with low environmental impact. Field tests will be carried out in different sites in Europe characterized by different climatic conditions to check the simplicity of the installation procedure and the performance of the panels in terms of energy efficiency and environmental impact. Ključne besede: prefabriced elements, geopolymers, CDW Objavljeno v DiRROS: 08.03.2024; Ogledov: 325; Prenosov: 162
Celotno besedilo (1,99 MB) Gradivo ima več datotek! Več... |
3. B-IMPACT project : eco-friendly and non-hazardous coatings for the protection of outdoor bronzesGiulia Masi, Maëlenn Aufray, A. Balbo, E. Bernardi, Maria Chiara Bignozzi, Cristina Chiavari, J. Esvan, Nina Gartner, V. Grassi, Claudie Josse, Tadeja Kosec, Carla Martini, Cecilia Monticelli, Luka Škrlep, W. Sperotto, Erika Švara Fabjan, E. Tedesco, F. Zanotto, Luc Robbiola, 2020, objavljeni znanstveni prispevek na konferenci Povzetek: Application of protective coatings is the most widely used conservation treatment for outdoor bronzes. Eco-friendly and non-hazardous coatings are currently needed for conservation of outdoor bronze monuments. To fulfil this need, the M-ERA.NET European research project B-IMPACT (Bronze-IMproved non-hazardous PAtina CoaTings) aimed at assessing the protectiveness of innovative coatings for historical and modern bronze monuments exposed outdoors.
In this project, two bronze substrates (historical Cu-Sn-Zn-Pb and modern Cu-Si-Mn alloys) were artificially patinated, by acid rain solution using dropping test and by "liver of sulphur" procedure (K2S aqueous solution) to obtain black patina, respectively. Subsequently, the application of several newly developed protective coatings was carried out and their performance was investigated by preliminary electrochemical tests. In the following steps of the work, the assessment of the best-performing coatings was carried out and their performance was compared to Incralac, one of the most widely used protective coatings in conservation practice. A multi-analytical approach was adopted, considering artificial ageing (carried out in representative conditions, including exposure to rain runoff, stagnant rain and UV radiation) and metal release, as well as visual aspect (so as to include aesthetical impact among the coating selection parameters) and morphological and structural evolution of the coated surfaces due to simulated outdoor exposure. Lastly, also the health impact of selected coatings was assessed by occupational hazard tests. The removability and re-applicability of the best-performing coatings were also assessed. The best alternatives to the conventional Incralac exhibited were: (i) fluoroacrylate blended with methacryloxy-propyl-trimethoxy-silane (FA-MS) applied on patinated Cu-Sn-Zn-Pb bronze and (ii) 3-mercapto-propyl-trimethoxysilane (PropS-SH) applied on patinated Cu-Si-Mn bronze. Ključne besede: bronze, patina, protective coatings, eco-friendly, corrosion, aging Objavljeno v DiRROS: 01.03.2024; Ogledov: 337; Prenosov: 212
Celotno besedilo (2,01 MB) Gradivo ima več datotek! Več... |
4. Development of multi-component fluoropolymer based coating on simulated outdoor patina on quaternary bronzeTadeja Kosec, Luka Škrlep, Erika Švara Fabjan, Andrijana Sever Škapin, Giulia Masi, Elena Bernardi, Cristina Chiavari, Claudie Josse, Jerome Esvan, Luc Robbiola, 2019, izvirni znanstveni članek Povzetek: Bronze reacts with oxygen, humidity, and pollutants in the atmosphere so that a patina forms. Natural exposure to an outdoor atmosphere can be simulated and accelerated in order to achieve a patina that mimics outdoor ancient patina. In order to avoid the uncontrolled dissolving of either the natural or artificially formed patina, protection of the patina is needed.
In this study, a multi-component fluoropolymer based coating for the protection of bronze patina was developed. In order to provide various functionalities of the coating (such as the hydrophobicity of the coating surface, obtaining interactions within the coating itself as well as a bronze substrate and inhibiting the corrosion processes), a fluoroacrylate coating with appropriate adhesion promoter was suggested, with and without a silane modified benzotriazole inhibitor. The protective efficiency and durability of the applied coatings were investigated electrochemically using potentiodynamic tests and electrochemical impedance spectroscopy in a simulated acid rain solution. All of the developed coatings showed a significant decrease in the corrosion current density. The self-assembled single layer coating (FA-MS) also showed 100% inhibition efficiency. After ageing the coating remained transparent and did not change by UV exposure and/or thermal cycling. The patina and coating investigations using FIB-SEM and EDX showed that the latter coating (FA-MS) successfully covered the surface of the patinated bronze. The mechanism of the bonding was proposed and supported with the spectroscopic observation of a thin and even coating.
Ključne besede: bronze, patina, fluoropolymer coating, atmospheric corrosion Objavljeno v DiRROS: 25.10.2023; Ogledov: 565; Prenosov: 326
Celotno besedilo (2,17 MB) Gradivo ima več datotek! Več... |
5. Life cycle assessment of prefabricated geopolymeric façade cladding panels made from large fractions of recycled construction and demolition wasteDavor Kvočka, Anja Lešek, Friderik Knez, Vilma Ducman, Matteo Panizza, Constantinos Tsoutis, Adriana Bernardi, 2020, izvirni znanstveni članek Povzetek: The construction and demolition sector is one of the biggest consumers of natural resources in the world and consequently, one of the biggest waste producers worldwide. The proper management of construction and demolition waste (CDW) can provide major benefits for the construction and recycling industry. However, the recycling rate of CDW is relatively low, as there is still a lack of confidence in the quality of recycled CDW materials. Therefore, new research projects are looking for innovative solutions within recycling of CDW in order to overcome uncertainties currently associated with the use of construction products made from recycled or re-used CDW. In this paper, a “cradle-to-cradle” life cycle assessment (LCA) study has been conducted to investigate the environmental performance of the prefabricated geopolymeric façade cladding panels made from large fractions of CDW. The LCA results indicate that the majority of the environmental burden arises within the manufacturing stage; however, the environmental burden can be reduced with simple optimisation of the manufacturing process. Furthermore, the environmental impact of the prefabricated geopolymeric façade cladding panels is generally lower than the environmental burden associated with the façade cladding panels made from virgin materials. Ključne besede: construction and demolition waste, alkali activated materials, geopolymers, LCA Objavljeno v DiRROS: 24.08.2023; Ogledov: 441; Prenosov: 223
Celotno besedilo (2,03 MB) Gradivo ima več datotek! Več... |
6. Up-scaling and performance assessment of façade panels produced from construction and demolition waste using alkali activation technologyAna Frankovič, Vilma Ducman, Sabina Dolenec, Matteo Panizza, Sergio Tamburini, Marco Natali, Katherine-Maria Pappas, Constantinos Tsoutis, Adriana Bernardi, 2020, izvirni znanstveni članek Povzetek: Novel prefabricated insulating façade panels were developed from construction and demolition waste (CDW) aggregates under the framework of the European H2020 project InnoWEE. These non-structural components, aimed at improving the thermal efficiency of existing buildings, consist of an insulating plate covered by a facing layer made of CDW aggregates bound with metakaolin, furnace slag and class F fly ash activated by a potassium silicate solution. The paper presents the design and assessment of the binder and panels for exterior use, taking into account mechanical performance, behaviour in the presence of water and durability issues. Testing was carried out on both laboratory prototypes and panels from the pilot industrial production. Ključne besede: construction and demolition waste, alkali activated materials, geopolymers, properties, up-scalimg Objavljeno v DiRROS: 21.08.2023; Ogledov: 441; Prenosov: 256
Celotno besedilo (2,99 MB) Gradivo ima več datotek! Več... |