Digital repository of Slovenian research organisations

Search the repository
A+ | A- | Help | SLO | ENG

Query: search in
search in
search in
search in

Options:
  Reset


Query: "keywords" (restrained shrinkage) .

1 - 2 / 2
First pagePrevious page1Next pageLast page
1.
Large ring test for evaluation of restrained shrinkage cracking : calibration and experimental trial
Zhongyu Xu, Lucija Hanžič, Harry Asche, Jurij Karlovšek, 2024, original scientific article

Abstract: The durability of shotcrete tunnel linings is significantly affected by restrained shrinkage cracking. Given the unique characteristics of shotcrete applied in tunnel linings, especially when dealing with accelerated shotcrete containing reinforcement fibres, it is necessary to upscale the ring test commonly used. This paper presents a comprehensive experiment using large ring tests with cast concrete to investigate the impact of upscaling ring test geometry. The two ring specimens demonstrated comparable cracking age (22 days) and strain measured in the steel ring, suggesting that consistent results can be obtained through the proposed instrumentation, calibration, and correction methods. Moreover, the estimated induced tensile stresses of the concrete rings (2.8 and 2.7 MPa) are slightly lower than the predicted tensile strength (3.3 MPa) at the age of cracking, which indicates that some driving forces contributing to restrained shrinkage cracking were not indicated in the strain gauge readings. Furthermore, the study identified multi-crack formation and additional potential causes for crack initiation, which include self-restraint due to the moisture gradient in the vertical direction, deflection of the concrete ring caused by its self-weight, and friction on the contact surface of the support. Therefore, optimising the geometry of the ring specimens and the apparatus is imperative to minimise additional driving forces and unmeasurable restraints for crack initiation, especially when employing the stress rate method to assess cracking potential.
Keywords: concrete, restrained shrinkage, tunnel lining, large ring test
Published in DiRROS: 22.07.2024; Views: 110; Downloads: 125
.pdf Full text (3,00 MB)
This document has many files! More...

2.
Experimental and numerical investigation of restrained shrinkage of concrete
Lucija Hanžič, Jurij Karlovšek, Tomaž Hozjan, Sabina Huč, Zhongyu Xu, Igor Planinc, Johnny Ching Ming Ho, 2020, published scientific conference contribution

Abstract: To promote the understanding of shrinkage related behaviour of concrete used for tunnel linings the experimental and theoretical investigation including numerical and analytical approach was performed on ring-shaped specimens. Overall one analytical (an.) and two numerical models, namely (i) and (ii) were also developed. Models (an.) and (i) considered the restraining steel ring to be rigid, thus not exhibiting any deformation. Numerical model (ii) considered the steel ring to be deformable. The experimental set-up consisted of a large concrete ring with an inner diameter of 120 cm, an outer diameter of 160cm and 20 cm in height. The restraining steel ring was 5.5 cm thick. Two concrete rings were made, namely R1 with a low compressive strength of ~26MPa and the other, R2, with medium compressive strength of ~40 MPa. The strain was measured in the hoop direction on the inner circumference of the steel ring and on the outer circumference of the concrete ring. Concrete rings were subjected to circumferential drying. Numerical model (ii) predicted critical time to the formation of the first crack to be between 13 and 14 days. The experimentally determined critical time is found to be 11 to 13 days with cracks gradually opening over several days. This was indicated by changes in measured concrete and steel strain. Modelled concrete strain just before cracking was between -20 and -30 % 10-6 m m-1 however, measured concrete strain was ~150 % 10-6 m m-1. Modelled steel strain was between -30 and -40 % 10-6 m m-1 while measured steel strain was between -10 and 20 % 10-6 m m-1. These discrepancies, in particular the positive steel strain obtained in experiments, require further investigation and improvements of the experimental set-up.
Keywords: concrete, tunnel lining, restrained shrinkage, Reissner beam theory, modelling
Published in DiRROS: 19.01.2024; Views: 411; Downloads: 161
.pdf Full text (18,89 MB)
This document has many files! More...
Search done in 0.3 sec.
Back to top