Search the repository

A+ | A- | | SLO | ENG

Published in DiRROS: 16.01.2024; Views: 173; Downloads: 38
Full text (247,29 KB)

Abstract: The Kvarner fault divides the Microadria (Adria microplate, the Adria stable core) into the Po and Adria segments. The Istra block, which is sandwiched between the right-lateral Kvarner Fault and the left-lateral Sistiana Fault lies at the extreme eastern edge of the Po segment. Both faults run transversely to the Dinarides and reach their thrust boundary in the east. The Microadria has been moving towards the Dinarides since the Middle Miocene. The movement of the Istra block is exposed in relation to the neighbouring blocks, so an extensive pushed area (the Istra Pushed Area) was formed in the External Dinarides, which is bent towards the northeast. It is defined by two flexural zones, one lying in the extension of the Sistiana Fault and the other in the extension of the Kvarner Fault. The structure of the Dinaric thrust border on the north-eastern side of the Istra block is complex. Its prominent structural element is the Črni Kal Anomaly, due to which a zone of increased compression developed within the Istra Pushed Area and transversely to the Dinarides (Kraški rob – Hrušica Traverse), which lies between the Sistiana and Kvarner Flexural Zones. In terms of kinematics, it differs greatly from these two, and various geomorphologically responsive deformations have occurred within it. Mt. Vremščica (1027 m), which represents a transpressive anticline within the wider zone of the Raša Fault is the most prominent. In order to understand the genesis of the Classical Karst relief, it is important to know that the Mt. Vremščica ridge rose from the levelled karst surface.
Keywords: NE Microadria (Adria Microplate), Istra peninsula, Istra Pushed Area, Črni Kal Anomaly, Kraški rob – Mt. Hrušica Traverse, stacked structure, envelope fault
Published in DiRROS: 15.01.2024; Views: 159; Downloads: 130
Full text (36,01 MB)

Keywords: radiacija, biokemija, encimi, proteini, fibroblasti, celice
Published in DiRROS: 10.01.2024; Views: 193; Downloads: 38
Full text (553,47 KB)

Keywords: project Life IP CARE4CLIMATE, land use, land use changes, forestry, activities
Published in DiRROS: 09.01.2024; Views: 190; Downloads: 0

Abstract: In recent years great attention has been placed by the building sector on alkali-activated technology based on metakaolin, fly ash and ground granulated blast furnace slag (GGBFS), but also on emerging precursors such as by-products from non-ferrous metallurgy. The present work focuses on the development of alkali-activated binders from two slags, one from primary and one from secondary copper production, which were finely milled, blended with GGBFS, and activated with K-based alkali silicate solution with a 1.7 SiO2/K2O molar ratio. The aggregate to paste mass ratio was 2. The mixtures were cast, and cured for a designated time at room temperature and 60% RH. The so-obtained paving blocks were then tested in accordance with European standard for concrete paving blocks. The following properties were measured: splitting tensile strength, abrasion resistance, slip and skid resistance, resistance to freeze-thaw and resistance to freeze-thaw in the presence of de-icing salts. Their properties were compared to those of commercially available concrete paving blocks, and it was found that the performance of the alkali-activated pavers was generally comparable with the concrete pavers, while certain properties (e.g., abrasion resistance, freeze-thaw resistance and freeze-thaw resistance in presence of de-icing salts) were considerably better.
Keywords: slags, alkali activated pavers, properties
Published in DiRROS: 21.12.2023; Views: 165; Downloads: 62
Full text (4,29 MB)
This document has many files! More...