Search the repository

A+ | A- | | SLO | ENG

Abstract: Lateral flow immunoassays (LFIAs) are a simple diagnostic device used to detect targeted analytes. Wasted and unused rapid antigen lateral flow immunoassays represent mass waste that needs to be broken down and recycled into new material components. The aim of this study was to recover gold nanoparticles that are used as markers in lateral flow immunoassays. For this purpose, a dissolution process with aqua regia was utilised, where gold nanoparticles were released from the lateral flow immunoassay conjugate pads. The obtained solution was then concentrated further with gold chloride salt (HAuCl4) so that it could be used for the synthesis of new gold nanoparticles in the process of ultrasonic spray pyrolysis (USP). Various characterisation methods including scanning electron microscopy, transmission electron microscopy, ultraviolet-visible spectroscopy and optical emission spectrometry with inductively coupled plasma were used during this study. The results of this study showed that the recovery of gold nanoparticles from lateral flow immunoassays is possible, and the newly synthesised gold nanoparticles represent the possibility for incorporation into new products.
Keywords: gold nanoparticles, recovery, LFIA, ultrasonic spray pyrolysis, characterisation
Published in DiRROS: 02.02.2024; Views: 254; Downloads: 101
Full text (6,25 MB)
This document has many files! More...

Abstract: Laser texturing with a dimple pattern was applied to modify a Ti6Al4V alloy at the micro level, aiming to improve its friction and wear resistance in combination with oil lubrication to optimize the performance in demanding industrial environments. The tribological analysis was performed on four different dimple-textured surfaces with varying dimple size and dimple-to-dimple distance and under lubrication with three different oils, i.e., T9, VG46, and VG100, to reflect the oil viscosity’s influence on the friction/wear of the laser-textured Ti6Al4V alloy. The results show that the surfaces with the highest texture density showed the most significant COF reduction of around 10% in a low-viscosity oil (T9). However, in high-viscosity oils (VG46 and VG100), the influence of the laser texturing on the COF was less pronounced. A wear analysis revealed that the laser texturing intensified the abrasive wear, especially on surfaces with a higher texture density. For low-texturing-density surfaces, less wear was observed for low- and medium-viscosity oils (T9 and VG46). For medium-to-high-texturing densities, the high-viscosity oil (VG100) provided the best contact conditions and wear results. Overall, reduced wear, even below the non-texturing case, was observed for sample 50–200 in VG100 lubrication, indicating the combined effect of oil reservoirs and increased oil-film thickness within the dimples due to the high viscosity.
Keywords: oil lubrication, surface modification, Ti-based alloy, tribology
Published in DiRROS: 01.02.2024; Views: 270; Downloads: 110
Full text (4,00 MB)
This document has many files! More...

Keywords: interim storage, spent fuel, borated stainless steel, cold working, bending
Published in DiRROS: 01.02.2024; Views: 217; Downloads: 101
Full text (10,05 MB)
This document has many files! More...

Keywords: Al-Ti-B grain-refiners, quality, TiB2 particles, Al3Ti particles, electrical resistance measurements
Published in DiRROS: 01.02.2024; Views: 250; Downloads: 103
Full text (8,93 MB)
This document has many files! More...

Keywords: martensitic stainless steel, boron, nitrogen, wear, machinability, polishability
Published in DiRROS: 01.02.2024; Views: 256; Downloads: 110
Full text (7,53 MB)
This document has many files! More...