Search the repository

A+ | A- | | SLO | ENG

Abstract: We present undercooling (∆T) experiments aimed at investigating the effect of growth kinetics on the textural and compositional evolution of clinopyroxene crystals growing from a high-K basalt erupted during the 2003 paroxysm of Stromboli volcano (Italy). The experiments were performed at P = 350 MPa, T = 1050–1210 °C, H2Omelt = 0–3 wt%, and fO2 = Ni-NiO + 1.5 buffer. An initial stage of supersaturation was imposed to the melt under nominally anhydrous (∆Tanh = 10–150 °C) and hydrous (∆Thyd = 25–125 °C) conditions. Afterwards, this supersaturation state was mitigated by melt relaxation phenomena over an annealing time of 24 h. Results show that plagioclase is the liquidus mineral phase of the high-K basalt at ∆Tanh = 10 °C and dominates the phase assemblage as the degree of undercooling increases. Conversely, clinopyroxene and spinel co-saturate the melt at ∆Thyd = 25 °C, followed by the subordinate formation of plagioclase. At ∆Tanh/hyd ≤ 50 °C, the textural maturation of clinopyroxene produces polyhedral crystals with {−111} (hourglass) and {hk0} (prism) sectors typical of a layer-by-layer growth mechanism governed by an interface-controlled crystallization regime. At ∆Tanh/hyd ≥ 75 °C, the attainment of dendritic and skeletal morphologies testifies to the establishment of diffusion-limited reactions at the crystal-melt interface. 3D reconstructions of synchrotron radiation X-ray microtomographic data reveal a composite growth history for clinopyroxene crystals obtained at ∆Tanh/hyd ≥ 95 °C. The early stage of melt supersaturation produces rosette-like structures composed of dendritic branches of clinopyroxene radiating from a common spinel grain, which acts as surface for heterogeneous nucleation. As diffusive relaxation phenomena progress over the annealing time, the elongate dendrites that constitute the inner crystal domain are partially infilled by the melt and develop skeletal overgrowths in the outer domain. With the increasing degree of undercooling, TAl and M1Ti cations are progressively incorporated in the lattice site of clinopyroxene at the expense of TSi and M1Mg cations. Because of the effect of H2Omelt on the liquidus depression and melt depolymerization, crystals obtained at ∆Thyd are also more enriched in TAl and M1Ti and depleted in TSi and M1Mg than those growing at ∆Tanh. The emerging picture is that the morphological and geochemical evolution of clinopyroxene is mutually controlled by the combined effects of melt supersaturation and relaxation phenomena. A new empirical relationship based on the cation exchange reactions in the lattice site of clinopyroxene is finally proposed to estimate the degree of undercooling governing the crystallization of augitic phenocrysts erupted during normal and violent explosions at Stromboli.
Keywords: clinopyroxene, undercooling, hourglass, crystallization, microtomography
Published in DiRROS: 27.10.2023; Views: 570; Downloads: 318
Full text (6,46 MB)
This document has many files! More...

Abstract: The present study deals with the characterisation of pigments used in two overlaid gothic wall paintings from the former 13th century Minorite church of St. Francis of Assisi (Koper, Slovenia), in order to define differences in the technologies used. Paint layer samples were analysed via Raman microspectroscopy, supported by SEM/EDS and FTIR analysis, when necessary. The results revealed that the 14th century mural was painted mainly a fresco with final elements a secco, a technique typical of Italian mediaeval wall painting. In contrast, the 15th century painting was executed mostly a secco, a technique often applied in Northern Europe and the Alpine region. The differences between the two paintings are especially obvious in the pigments applied. While the earlier painting is characterised by azurite, carbon black, red and yellow ochres, lime white and green earth, the palette used for the younger painting is much broader. In addition to red and yellow ochres, carbon black and lime white, lead pigments such as lead white, red lead and lead-tin yellow type I were also determined, as well as a number of expensive pigments including cinnabar, azurite and malachite. Also found in the younger painting was the rare orange yellow pigment vanadinite. In both layers, azurite was applied a secco for the background area. Gilding was confirmed in both layers, carried out as application of gold leaves on red bole (in the earlier mural) and on mordant (on a younger, superimposed (overlaid painting), which is quite exclusive and rare for Slovene mediaeval painting. In the younger layer also a use of tin foil for secondary elements was discovered.
Keywords: wall paintings, pigments, Gothic, golding, Raman microspectroscopy
Published in DiRROS: 27.10.2023; Views: 499; Downloads: 219
Full text (4,58 MB)
This document has many files! More...

Keywords: dendrorkonologija, učbeniki
Published in DiRROS: 26.10.2023; Views: 542; Downloads: 155
Full text (4,09 MB)

Abstract: In the field of surface treatment, laser colour marking can be used to produce coloured marks on the surfaces of metals. Laser colour markings can be applied to various materials, but on titanium alloys a wide spectra of vivid colours can be achieved. This study presents an analysis of the corrosion properties of laser treated surfaces that were exposed to aggressive environments. Different samples were prepared with laser light of various power intensities and processing speeds. The samples were prepared on low alloyed Ti. Electrochemical, spectroscopic and microstructural analyses were conducted in order to study the properties of the laser treated surfaces. Corrosion testing showed different effects of laser power and production speed on the properties of the laser treated surfaces. It was shown that a high intensity and slow processing rate affect the surfaces by forming oxides that are relatively stable in a corrosive environment of 0.1 M NaCl. Spectroscopic investigations including scanning electron microscopy (SEM) and X-ray photoelectron spectroscopy (XPS) analyses showed the differences in chemical structure of the surface layer formed after laser treatment. Similarly, microstructural investigations showed different effects on the surface and sub-surface layer of the laser treated samples.
Keywords: Ti alloy, laser treatment, XPS, corrosion
Published in DiRROS: 25.10.2023; Views: 493; Downloads: 197
Full text (3,16 MB)
This document has many files! More...

Keywords: varstvo gozdov, morfološke analize, Agrilus anxius, brezov krasnik
Published in DiRROS: 24.10.2023; Views: 544; Downloads: 0