| Naslov: | RILEM TC 247-DTA round robin test : mix design and reproducibility of compressive strength of alkaliactivated concretes |
|---|
| Avtorji: | ID Provis, John L. (Avtor)
ID Arbi, Kamel (Avtor)
ID Bernal, Susana (Avtor)
ID Bondar, Dali (Avtor)
ID Buchwald, Anja (Avtor)
ID Castel, Arnaud (Avtor)
ID Chithiraputhiran, Sundararaman (Avtor)
ID Cyr, Martin (Avtor)
ID Dehghan, Alireza (Avtor)
ID Dombrowski-Daube, Katja (Avtor)
ID Dubey, Ashish (Avtor)
ID Ducman, Vilma (Avtor)
ID Gluth, Gregor J. G. (Avtor)
ID Nanukuttan, Sreejith (Avtor)
ID Peterson, Karl (Avtor)
ID Puertas, Francisca (Avtor)
ID Riessen, Arie van (Avtor)
ID Torres-Carrasco, Manuel (Avtor)
ID Ye, Guang (Avtor)
ID Zuo, Yibing (Avtor) |
|---|
| Datoteke: |  PDF - Predstavitvena datoteka, prenos (431,19 KB)
MD5: F33766F2FB8E794C0186B6897ABECBD6
 URL - Izvorni URL, za dostop obiščite http://dx.doi.org/10.1617/s11527-019-1396-z
|
|---|
| Jezik: | Angleški jezik |
|---|
| Tipologija: | 1.01 - Izvirni znanstveni članek |
|---|
| Organizacija: |  ZAG - Zavod za gradbeništvo Slovenije
|
|---|
| Povzetek: | The aim of RILEM TC 247-DTA Durability Testing of Alkali-Activated Materials is to identify and validate methodologies for testing the durability of alkali-activated concretes. To underpin the durability testing work of this committee, five alkali-activated concrete mixes were developed based on blast furnace slag, fly ash, and flash-calcined metakaolin. The concretes were designed with different intended performance levels, aiming to assess the capability of test methods to discriminate between concretes on this basis. A total of fifteen laboratories worldwide participated in this round robin test programme, where all concretes were produced with the same mix designs, from single-source aluminosilicate precursors and locally available aggregates. This paper reports the mix designs tested, and the compressive strength results obtained, including critical insight into reasons for the observed variability in strength within and between laboratories. |
|---|
| Ključne besede: | alkali-activated materials (AAM), mechanical properties, test method, Rilem TC, durability |
|---|
| Status publikacije: | Objavljeno |
|---|
| Verzija publikacije: | Objavljena publikacija |
|---|
| Datum objave: | 10.09.2019 |
|---|
| Založnik: | E. & F. N. Spon, RILEM Publications |
|---|
| Leto izida: | 2019 |
|---|
| Št. strani: | str. 1-13 |
|---|
| Številčenje: | Vol. 52, issue 5 |
|---|
| PID: | 20.500.12556/DiRROS-16968  |
|---|
| UDK: | 620.1/.2 |
|---|
| ISSN pri članku: | 1359-5997 |
|---|
| DOI: | 10.1617/s11527-019-1396-z |
|---|
| COBISS.SI-ID: | 2485607 |
|---|
| Avtorske pravice: | © The Author(s) 2019 |
|---|
| Opomba: | Article: 99;
|
|---|
| Datum objave v DiRROS: | 14.09.2023 |
|---|
| Število ogledov: | 240 |
|---|
| Število prenosov: | 140 |
|---|
| Metapodatki: |     |
|---|
|
:
|
Kopiraj citat |
|---|
| | | | Objavi na: |  |
|---|
Postavite miškin kazalec na naslov za izpis povzetka. Klik na naslov izpiše
podrobnosti ali sproži prenos. |
