| Naslov: | Using bridge weigh-in-motion systems to monitor single-span bridge influence lines |
|---|
| Avtorji: | ID Žnidarič, Aleš (Avtor)
ID Kalin, Jan (Avtor) |
|---|
| Datoteke: |  URL - Izvorni URL, za dostop obiščite https://link.springer.com/article/10.1007/s13349-020-00407-2
Opis: Odprti dostop
 PDF - Predstavitvena datoteka, prenos (2,38 MB)
MD5: 2CC2CACB1645650A8F49962417585CED
|
|---|
| Jezik: | Angleški jezik |
|---|
| Tipologija: | 1.01 - Izvirni znanstveni članek |
|---|
| Organizacija: |  ZAG - Zavod za gradbeništvo Slovenije
|
|---|
| Povzetek: | Bridge weigh-in-motion systems use instrumented bridges or culverts to weigh vehicles as they pass over the structures. They also provide data to allow the calculation of several bridge performance indicators. The article starts with the basics of a bridge weigh-in-motion system and briefly describes two key bridge performance indicators, girder distribution factor and dynamic amplification factor, which are also derived from B-WIM measurements. The central part of the article focuses on monitoring of influence lines, the third key parameter that characterises the bridge performance under traffic loads. First, the method of calculating the bending moment influence lines from random heavy traffic is described. A coefficient of rotational stiffness is introduced, which defines the shape of influence lines around the supports as a linear combination of the ideal simply supported and fixed supported influence lines, to allow quantifying the influence line changes. Then the long-term monitoring of influence lines is investigated on four different single-span test bridges. The initial focus is given on the examination of the effect of temperature on the shape of influence lines. Finally, two sets of influence lines are compared on one test bridge, one from before and the other from after replacing the expansion joints and bearings. The work done so far confirms that calculating of influence lines from random vehicles with a B-WIM system is entirely feasible and that differences in their shape can be detected on single-span bridges. What remains to be investigated is the comparison of these differences to the actual damages and under which circumstances the proposed procedure can compete with or better the routine bridge inspection and the conventional monitoring techniques. |
|---|
| Ključne besede: | bridge loading, bridge response, temperature dependency, influence line, monitoring |
|---|
| Status publikacije: | Objavljeno |
|---|
| Verzija publikacije: | Objavljena publikacija |
|---|
| Datum objave: | 31.07.2020 |
|---|
| Založnik: | Springer |
|---|
| Leto izida: | 2020 |
|---|
| Št. strani: | str. 743-756 |
|---|
| Številčenje: | Vol. 10, iss. 5 |
|---|
| PID: | 20.500.12556/DiRROS-16939  |
|---|
| UDK: | 624 |
|---|
| ISSN pri članku: | 2190-5452 |
|---|
| DOI: | 10.1007/s13349-020-00407-2 |
|---|
| COBISS.SI-ID: | 24290307 |
|---|
| Avtorske pravice: | © The Author(s) 2020 |
|---|
| Datum objave v DiRROS: | 12.09.2023 |
|---|
| Število ogledov: | 352 |
|---|
| Število prenosov: | 133 |
|---|
| Metapodatki: |     |
|---|
|
:
|
Kopiraj citat |
|---|
| | | | Objavi na: |  |
|---|
Postavite miškin kazalec na naslov za izpis povzetka. Klik na naslov izpiše
podrobnosti ali sproži prenos. |
