| Naslov: | Composite beams made of waste wood-particle boards, fastened to solid timber frame by dowel-type fasteners |
|---|
| Avtorji: | ID Kržan, Meta (Avtor)
ID Pazlar, Tomaž (Avtor)
ID Ber, Boštjan (Avtor) |
|---|
| Datoteke: |  URL - Izvorni URL, za dostop obiščite https://www.mdpi.com/1996-1944/16/6/2426
 PDF - Predstavitvena datoteka, prenos (7,82 MB)
MD5: F978E6EBEE4D0A1494478268D2C8E4EC
|
|---|
| Jezik: | Angleški jezik |
|---|
| Tipologija: | 1.01 - Izvirni znanstveni članek |
|---|
| Organizacija: |  ZAG - Zavod za gradbeništvo Slovenije
|
|---|
| Povzetek: | To increase the sustainability of prefabricated timber buildings and constructions, composite timber beams with “box” cross-sections were developed in collaboration with an industry partner. They were constructed from a solid timber frame and from webs made of residual waste wood- particle boards from prefabricated timber buildings production. The developed beams’ design concepts presented in this paper were governed by architectural features of prefabricated timber buildings, geometrical limitations, available production technology, and structural demand related to various possible applications. The paper presents the results of experimental bending tests of six variations of the developed composite timber beams constructed by mechanical fasteners only. The developed design concept of composite timber beams without adhesives is beneficial compared to glued beams in terms of design for deconstruction and lower VOC emissions. The tests were conducted to study the influence of the following parameters on the beams’ mechanical behavior: (i) web material (oriented strand boards (OSBs) vs. cement-particle boards); (ii) the influence of beam timber frame design (flanges and web stiffeners vs. flanges, web stiffeners, and compressive diagonals), and (iii) the influence of stiffener–flange joint design. Besides the beams’ load-bearing capacities, their linear and non-linear stiffness characteristics were the main research interest. While adding compressive timber diagonals did not prove to significantly increase the stiffness of the beams in the case of cement-particle board webs, it increased their load-bearing capacity by enabling the failure of flanges instead of prior webs and stiffener–flange joints failure. For beams with OSB webs, failure of the bottom flange was achieved already with the “basic” timber frame design, but timber diagonals proved beneficial to increase the stiffness characteristics. Finally, mechanical characteristics of the developed beams needed in structural design for their application are provided together with further development guidelines. |
|---|
| Ključne besede: | composite timber beam, box beam, OSB, cement-particle boards, innovative engineered wood product, experimental tests, flexural performance, mechanical fasteners, open access |
|---|
| Status publikacije: | Objavljeno |
|---|
| Verzija publikacije: | Objavljena publikacija |
|---|
| Datum objave: | 18.03.2023 |
|---|
| Založnik: | Molecular Diversity Preservation International |
|---|
| Leto izida: | 2023 |
|---|
| Št. strani: | str. 1-16 |
|---|
| Številčenje: | Vol. 16, iss. 6 [article no. 2426] |
|---|
| PID: | 20.500.12556/DiRROS-16402  |
|---|
| UDK: | 624.07 |
|---|
| ISSN pri članku: | 1996-1944 |
|---|
| DOI: | 10.3390/ma16062426 |
|---|
| COBISS.SI-ID: | 146101251 |
|---|
| Avtorske pravice: | © 2023 by the authors.
Licensee MDPI, Basel, Switzerland. |
|---|
| Opomba: | Nasl. z nasl. zaslona;
Opis vira z dne 22. 3. 2023; |
|---|
| Datum objave v DiRROS: | 29.05.2023 |
|---|
| Število ogledov: | 633 |
|---|
| Število prenosov: | 362 |
|---|
| Metapodatki: |    |
|---|
|
:
|
Kopiraj citat |
|---|
| | | | Objavi na: |  |
|---|
Postavite miškin kazalec na naslov za izpis povzetka. Klik na naslov izpiše
podrobnosti ali sproži prenos. |
