Digitalni repozitorij raziskovalnih organizacij Slovenije

Iskanje po repozitoriju
A+ | A- | Pomoč | SLO | ENG

Iskalni niz: išči po
išči po
išči po
išči po

Možnosti:
  Ponastavi


Iskalni niz: "ključne besede" (material properties) .

1 - 2 / 2
Na začetekNa prejšnjo stran1Na naslednjo stranNa konec
1.
The use of paper industry side product in construction
Barbara Likar, Laura Vovčko, 2020, objavljeni znanstveni prispevek na konferenci

Povzetek: The amount of waste material and side products of various industrial plants is increasing, which leads into waste accumulation and lack of space in disposal landfills. Paper industry, with its side products paper sludge and ash, faces these same issues. To reduce the accumulation of these materials, we explored the possibility of their use in construction. At first a series of geomechanical tests was conducted on a product consisting of fly ash and bottom ash. Based on the laboratory results test fields were constructed, where the preparation and installation technologies were tested. The fields were exposed to the atmospheric conditions, so durability of the product in the natural environment was proven. Since the composition of both fly ash and bottom ash depends on the paper industry process, a continuous monitoring of their characteristics was established.
Ključne besede: paper industry, fly ash, bottom ash, construction material, geomechanical properties
Objavljeno v DiRROS: 05.03.2024; Ogledov: 149; Prenosov: 52
.pdf Celotno besedilo (521,45 KB)
Gradivo ima več datotek! Več...

2.
3D finite element analysis of a concrete dam behavior under changing hydrostatic load : a case study
Pavel Žvanut, 2022, izvirni znanstveni članek

Povzetek: In this study, a large arch-gravity Moste Dam was analyzed, where an automated system for the measurements of horizontal displacements of the upper part of the dam was established. Two-dimensional (2D) and three-dimensional (3D) analyses of dam behavior, taking into account the earth pressures and the hydrostatic load, using the finite element method (FEM)-based computer program DIANA, were performed. The influence of lowering the water level of the reservoir by 6.2 m, on the horizontal displacements of the upper part of the dam, at stationary temperature conditions, was investigated. It was found that the results of the performed 2D and 3D FEM analyses fitted in very well with the result of experimentally determined measurement of horizontal displacements (which was 0.48 mm in the upstream direction) that was obtained using a hanging pendulum. An additional comparison of the results of 3D calculations showed that the finite element mesh density had a small effect on the calculated horizontal displacements.
Ključne besede: concrete dam, finite element method, material properties, structure behavior, measuring instruments, monitoring, ime series analysis, horizontal displacements, hydrostatic pressure
Objavljeno v DiRROS: 21.06.2023; Ogledov: 351; Prenosov: 198
.pdf Celotno besedilo (5,35 MB)
Gradivo ima več datotek! Več...
Iskanje izvedeno v 0.08 sek.
Na vrh