1951. Corrosion performance of steel in blended cement pore solutionsMiha Hren, Tadeja Kosec, Andraž Legat, Violeta Bokan-Bosiljkov, 2019, izvirni znanstveni članek Povzetek: Blended cements might change the chemistry of the pore solution and subsequently affect the corrosion of steel in concrete. Pore solutions were extracted, analyzed and compared from mortars made of CEM I, CEM II, CEM III and CEM IV cements. Three combinations of carbonation and chloride states were studied, i.e., non-carbonated without chlorides, non-carbonated with chlorides and carbonated with chlorides. Different electrochemical and spectroscopic techniques were used to study the electrochemical properties, the type and the extent of the corrosion products, as well as the type and the extent of the corrosion damage. It was confirmed that the most corrosive environments were pore solutions extracted from the carbonated mortars with chlorides. In this environment the highest corrosion rate was observed for the CEM III pore solution, and the lowest for the CEM I. The extent and the type of corrosion products and the corrosion damage varied according to the environment.
Ključne besede: corrosion, blended cements, pore solution, mortar
Objavljeno v DiRROS: 14.09.2023; Ogledov: 309; Prenosov: 116
 Celotno besedilo (1,80 MB)
Gradivo ima več datotek! Več... |
1952. |
1953. Elektrolitsko markiranje farmakov z [sup]99mTCIN[sup]131JBoris Pihlar, M. Erjavec, Jože Marsel, 1979, izvirni znanstveni članek Ključne besede: analizna kemija, radiokemija, elektrokemija, elektrolitsko markiranje, biološka aktivnost, radioizotopi, tehnecij, jod
Objavljeno v DiRROS: 14.09.2023; Ogledov: 276; Prenosov: 70
Celotno besedilo (232,42 KB) |
1954. Investigations of 6-pane glazing : properties and possibilitiesAleš Kralj, Marija Drev, Matjaž Žnidaršič, Boštjan Černe, Jože Hafner, Bjørn Petter Jelle, 2019, izvirni znanstveni članek Povzetek: Today there is increasing interest and demand for energy savings in the building sector. Windows still represent a weak point in the building envelope with respect to thermal performance due to thermal losses from the interior to the exterior as well as overheating of the interior due to excessive solar radiation from the exterior environment into the interior. However, windows and glazing structures enable the utilisation of daylight and heat from incident solar radiation, while at the same time providing comfort and a view to the outdoor surroundings. Multipane glazing and windows may represent a possible way to lower energy consumption related to heating and cooling. In this study, a multipane glazing structure, more specifically a 6-pane glazing, has been constructed and investigated with regard to various properties and possibilities. The general configuration of the 6-pane glazing is described. Furthermore, properties such as U-value, solar energy transmittance, visible transmittance, solar heat gain coefficient, glass pane temperatures, vapour permeability, economical aspects, and comfort of living, among others, are analysed. Finally, a case study is presented that demonstrates a 50% reduction in the annual energy consumption after renovation with this 6-pane glazing.
Ključne besede: window, multipane glazing, building, U-value, solar transmittance, temperature
Objavljeno v DiRROS: 14.09.2023; Ogledov: 317; Prenosov: 139
Celotno besedilo (1,74 MB)
Gradivo ima več datotek! Več... |
1955. Modificirajući uticaj na neke endokrine žlezde miša kod kasnih posledica subletalnog jonizacionog zračenjaMiroslav Kališnik, Olga Vraspir-Porenta, Metka Logonder-Mlinšek, Marjeta Zorc, Tatjana Lejko-Zupanc, Alenka Rus-Gaši, Draga Štiblar-Martinčič, Janez Škrk, 1979, izvirni znanstveni članek Objavljeno v DiRROS: 14.09.2023; Ogledov: 278; Prenosov: 63
Celotno besedilo (558,37 KB) |
1956. |
1957. |
1958. |
1959. RILEM TC 247-DTA round robin test : mix design and reproducibility of compressive strength of alkaliactivated concretesJohn L. Provis, Kamel Arbi, Susana Bernal, Dali Bondar, Anja Buchwald, Arnaud Castel, Sundararaman Chithiraputhiran, Martin Cyr, Alireza Dehghan, Katja Dombrowski-Daube, Ashish Dubey, Vilma Ducman, Gregor J. G. Gluth, Sreejith Nanukuttan, Karl Peterson, Francisca Puertas, Arie van Riessen, Manuel Torres-Carrasco, Guang Ye, Yibing Zuo, 2019, izvirni znanstveni članek Povzetek: The aim of RILEM TC 247-DTA Durability Testing of Alkali-Activated Materials is to identify and validate methodologies for testing the durability of alkali-activated concretes. To underpin the durability testing work of this committee, five alkali-activated concrete mixes were developed based on blast furnace slag, fly ash, and flash-calcined metakaolin. The concretes were designed with different intended performance levels, aiming to assess the capability of test methods to discriminate between concretes on this basis. A total of fifteen laboratories worldwide participated in this round robin test programme, where all concretes were produced with the same mix designs, from single-source aluminosilicate precursors and locally available aggregates. This paper reports the mix designs tested, and the compressive strength results obtained, including critical insight into reasons for the observed variability in strength within and between laboratories.
Ključne besede: alkali-activated materials (AAM), mechanical properties, test method, Rilem TC, durability
Objavljeno v DiRROS: 14.09.2023; Ogledov: 256; Prenosov: 148
Celotno besedilo (431,19 KB)
Gradivo ima več datotek! Več... |
1960. Aggregates obtained by alkali activation of fly ash : the effect of granulation, pelletization methods and curing regimesOgnjen Lj. Rudić, Vilma Ducman, Mirjana Malešev, Vlastimir Radonjanin, Suzana Draganić, Slobodan Šupić, Miroslava Radeka, 2019, izvirni znanstveni članek Povzetek: This paper presents results regarding the phase composition, microstructure and textural properties of two types of aggregates, which were prepared via crushing or pelletization of alkali-activated Class F fly ash and cured under different conditions. The alkali activator was the same for aggregate products, containing an alkaline solution consisting of 8 M NaOH and Na-silicate (8 M NaOH/Na-silicate = 1:2.5 mass ratio). The aforementioned properties were influenced by two different preparation procedures combined with varying curing regimes (under normal conditions at 20 %C, RH 40%60% for 28 and 120 days and under an accelerated regime, at 65 %C for 5 days). Aggregates were characterized using X-ray diffraction (XRD), Fourier-transform transmission infrared spectroscopy (FTIR), back scattered electron microscopy with energy dispersive spectrometer (BSE-EDS) analyses and mercury intrusion porosimetry (MIP). The results showed noteworthy structural and textural diversities between the two types of aggregate. The method of preparation and curing regime affected the formation of the N-A-S-H structure and the texture of the alkali-activated fly ash product, with the crushing method giving an advantage
Ključne besede: alkali activation, agregat, FTIR
Objavljeno v DiRROS: 14.09.2023; Ogledov: 254; Prenosov: 144
Celotno besedilo (5,27 MB)
Gradivo ima več datotek! Več... |
