| Naslov: | The effect of pore sealing in a multilayer ▫Si–O–Zr/Al_2O_3▫ coating designed to protect aluminium from corrosion |
|---|
| Avtorji: | ID Rodič, Peter, Institut "Jožef Stefan" (Avtor)
ID Kapun, Barbara, Institut "Jožef Stefan" (Avtor)
ID Milošev, Ingrid, Institut "Jožef Stefan" (Avtor) |
|---|
| Datoteke: |  URL - Izvorni URL, za dostop obiščite https://www.mdpi.com/2075-4701/13/12/1960
 PDF - Predstavitvena datoteka, prenos (11,89 MB)
MD5: D44C9257F673B17B835A46D12276981F
|
|---|
| Jezik: | Angleški jezik |
|---|
| Tipologija: | 1.01 - Izvirni znanstveni članek |
|---|
| Organizacija: |  IJS - Institut Jožef Stefan
|
|---|
| Povzetek: | This study deals with the combination of two corrosion protection strategies for aluminium: barrier protection (provided by a 3.8 μm thick hybrid sol–gel coating) and aluminium pore sealing via the use of a 100 nm thick layer of aluminium oxide. A Si–O–Zr hybrid sol–gel coating (TMZ) was synthesised by combining two separately prepared sols (i) tetraethyl orthosilicate and 3-methacryloxypropyl trimethoxysilane and (ii) zirconium(IV) n-propoxide chelated with methacrylic acid. The synthesis of the Si–O–Zr hybrid sol–gel was evaluated at various stages using real-time infrared spectroscopy. A 100 nm thick Al2O3 film was prepared via thermal atomic layer deposition at 160 °C using trimethyl aluminium and water as precursors. The coating and film properties were assessed via focused ion beam/scanning electron microscopy coupled with energy-dispersive X-ray spectrometry. Sealing with the Al2O3 film did not affect the microstructure and composition of the underlying sol–gel coating. The coating’s corrosion performance in 0.1 M NaCl solution was evaluated using electrochemical impedance spectroscopy. Compared to individual coatings, the multilayer TMZ/Al2O3 coating ensured prolonged (more than three weeks) durable corrosion protection for the aluminium. The impedance magnitude increased by two orders compared to the uncoated substrate (|Z|10 mHz from 16 kΩ cm2 to almost 830 MΩ cm2). Thus, the pore sealing of the sol–gel coating using an ALD alumina film produced a protective multilayer coating system, with |Z|10 mHz remaining above 5 MΩ cm2 after four weeks in NaCl solution. |
|---|
| Ključne besede: | aluminum, corrosion, hybrid sol-gel, atomic layer deposition, pore sealing |
|---|
| Status publikacije: | Objavljeno |
|---|
| Verzija publikacije: | Objavljena publikacija |
|---|
| Poslano v recenzijo: | 21.10.2023 |
|---|
| Datum sprejetja članka: | 28.11.2023 |
|---|
| Datum objave: | 30.11.2023 |
|---|
| Založnik: | MDPI |
|---|
| Leto izida: | 2023 |
|---|
| Št. strani: | str. 1-23 |
|---|
| Številčenje: | Vol. 13, iss. 12, [article no.] 1960 |
|---|
| Izvor: | Švica |
|---|
| PID: | 20.500.12556/DiRROS-22130  |
|---|
| UDK: | 54 |
|---|
| ISSN pri članku: | 2075-4701 |
|---|
| DOI: | 10.3390/met13121960 |
|---|
| COBISS.SI-ID: | 174730243 |
|---|
| Avtorske pravice: | © 2023 by the authors. |
|---|
| Opomba: | Nasl. z nasl. zaslona;
Opis vira z dne 4. 12. 2023;
|
|---|
| Datum objave v DiRROS: | 29.04.2025 |
|---|
| Število ogledov: | 697 |
|---|
| Število prenosov: | 322 |
|---|
| Metapodatki: |    |
|---|
|
:
|
Kopiraj citat |
|---|
| | | | Objavi na: |  |
|---|
Postavite miškin kazalec na naslov za izpis povzetka. Klik na naslov izpiše
podrobnosti ali sproži prenos. |
