Digitalni repozitorij raziskovalnih organizacij Slovenije

Izpis gradiva
A+ | A- | Pomoč | SLO | ENG

Naslov:Experimental investigation of the axial strength of glued-in rods in cross laminated timber
Avtorji:ID Azinović, Boris (Avtor)
ID Serrano, Erik (Avtor)
ID Kramar, Miha (Avtor)
ID Pazlar, Tomaž (Avtor)
Datoteke:URL URL - Izvorni URL, za dostop obiščite https://link.springer.com/article/10.1617/s11527-018-1268-y
 
.pdf PDF - Predstavitvena datoteka, prenos (4,13 MB)
MD5: DD3037D4452DE5F661B3979802486911
 
URL URL - Priloga, za dostop obiščite https://doi.org/10.1617/s11527-018-1268-y
Opis: Electronic supplementary material
 
Jezik:Angleški jezik
Tipologija:1.01 - Izvirni znanstveni članek
Organizacija:Logo ZAG - Zavod za gradbeništvo Slovenije
Povzetek:This paper presents results from an experimental assessment of glued-in rods in cross laminated timber (CLT). For the purposes of the study more than 60 pull-pull tests were performed, where the specimens varied in terms of bonded-in length (from 80 to 400 mm), rod diameter (16-24 mm) and rod-to-grain angle (parallel and perpendicular). Several different failure modes that are not common for other applications of glued-in rods (e.g., a failure between CLT layers) were obtained for the analysed CLT specimens. It was found that these failure mechanisms can substantially influence the obtained ultimate tension loads. At the end, the experimental results were compared with empirical and semi-empirical equations for estimating the pull-out strength of glued-in rods in structural timber and glulam. The comparison showed that most of the existing equations overestimate the ultimate tension loads for specimens with the rod parallel to the grain and underestimate the ultimate tension load for specimens with the rod perpendicular to the grain. The results vary because the possible CLT failure modes were not included in previous studies. Further studies are proposed to improve the equations for glued-in rods in CLT.
Ključne besede:glued-in rods, cross laminated timber (CLT), pull-pull experiment, glued-in length, rod-to-grain angle, failure mechanisms in CLT
Status publikacije:Objavljeno
Verzija publikacije:Objavljena publikacija
Datum objave:18.10.2018
Založnik:E. & F. N. Spon, RILEM Publications
Leto izida:2018
Št. strani:str. 1-16
Številčenje:Vol. 51, issue 6
PID:20.500.12556/DiRROS-17386 Novo okno
UDK:620.1/.2
ISSN pri članku:1359-5997
DOI:10.1617/s11527-018-1268-y Novo okno
COBISS.SI-ID:2408295 Novo okno
Avtorske pravice:© The Author(s) 2019
Opomba:Article:143;
Datum objave v DiRROS:29.11.2023
Število ogledov:749
Število prenosov:589
Metapodatki:XML DC-XML DC-RDF
:
AZINOVIĆ, Boris, SERRANO, Erik, KRAMAR, Miha in PAZLAR, Tomaž, 2018, Experimental investigation of the axial strength of glued-in rods in cross laminated timber. Materials and structures [na spletu]. 2018. Vol. 51, no. 6, p. 1–16. [Dostopano 15 april 2025]. DOI 10.1617/s11527-018-1268-y. Pridobljeno s: https://dirros.openscience.si/IzpisGradiva.php?lang=slv&id=17386
Kopiraj citat
  
Objavi na:Bookmark and Share


Postavite miškin kazalec na naslov za izpis povzetka. Klik na naslov izpiše podrobnosti ali sproži prenos.

Gradivo je del revije

Naslov:Materials and structures
Skrajšan naslov:Mat. struct.
Založnik:E. & F. N. Spon, RILEM Publications
ISSN:1359-5997
COBISS.SI-ID:18240005 Novo okno

Gradivo je financirano iz projekta

Financer:EC - European Commission
Program financ.:H2020
Številka projekta:739574
Naslov:Renewable materials and healthy environments research and innovation centre of excellence
Akronim:InnoRenew CoE
Financer:ARRS - Agencija za raziskovalno dejavnost Republike Slovenije
Številka projekta:P2-0273
Naslov:Gradbeni objekti in materiali

Licence

Licenca:CC BY 4.0, Creative Commons Priznanje avtorstva 4.0 Mednarodna
Povezava:http://creativecommons.org/licenses/by/4.0/deed.sl
Opis:To je standardna licenca Creative Commons, ki daje uporabnikom največ možnosti za nadaljnjo uporabo dela, pri čemer morajo navesti avtorja.
Začetek licenciranja:18.10.2018
Vezano na:Text and Data Mining valid from 2018-10-18

Sekundarni jezik

Jezik:Slovenski jezik
Ključne besede:lepljene palice, križno lepljen les (CLT), natezni preiskus, sidrna dolžina palice, usmerjenost palice glede na vlakna, porušni mehanizmi v CLT


Nazaj