| Title: | Experimental investigation of the axial strength of glued-in rods in cross laminated timber |
|---|
| Authors: | ID Azinović, Boris (Author)
ID Serrano, Erik (Author)
ID Kramar, Miha (Author)
ID Pazlar, Tomaž (Author) |
|---|
| Files: |  URL - Source URL, visit https://link.springer.com/article/10.1617/s11527-018-1268-y
 PDF - Presentation file, download (4,13 MB)
MD5: DD3037D4452DE5F661B3979802486911
URL - Supplement, visit https://doi.org/10.1617/s11527-018-1268-y
Description: Electronic supplementary material
|
|---|
| Language: | English |
|---|
| Typology: | 1.01 - Original Scientific Article |
|---|
| Organization: |  ZAG - Slovenian National Building and Civil Engineering Institute
|
|---|
| Abstract: | This paper presents results from an experimental assessment of glued-in rods in cross laminated timber (CLT). For the purposes of the study more than 60 pull-pull tests were performed, where the specimens varied in terms of bonded-in length (from 80 to 400 mm), rod diameter (16-24 mm) and rod-to-grain angle (parallel and perpendicular). Several different failure modes that are not common for other applications of glued-in rods (e.g., a failure between CLT layers) were obtained for the analysed CLT specimens. It was found that these failure mechanisms can substantially influence the obtained ultimate tension loads. At the end, the experimental results were compared with empirical and semi-empirical equations for estimating the pull-out strength of glued-in rods in structural timber and glulam. The comparison showed that most of the existing equations overestimate the ultimate tension loads for specimens with the rod parallel to the grain and underestimate the ultimate tension load for specimens with the rod perpendicular to the grain. The results vary because the possible CLT failure modes were not included in previous studies. Further studies are proposed to improve the equations for glued-in rods in CLT. |
|---|
| Keywords: | glued-in rods, cross laminated timber (CLT), pull-pull experiment, glued-in length, rod-to-grain angle, failure mechanisms in CLT |
|---|
| Publication status: | Published |
|---|
| Publication version: | Version of Record |
|---|
| Publication date: | 18.10.2018 |
|---|
| Publisher: | E. & F. N. Spon, RILEM Publications |
|---|
| Year of publishing: | 2018 |
|---|
| Number of pages: | str. 1-16 |
|---|
| Numbering: | Vol. 51, issue 6 |
|---|
| PID: | 20.500.12556/DiRROS-17386  |
|---|
| UDC: | 620.1/.2 |
|---|
| ISSN on article: | 1359-5997 |
|---|
| DOI: | 10.1617/s11527-018-1268-y |
|---|
| COBISS.SI-ID: | 2408295 |
|---|
| Copyright: | © The Author(s) 2019 |
|---|
| Note: | Article:143;
|
|---|
| Publication date in DiRROS: | 29.11.2023 |
|---|
| Views: | 557 |
|---|
| Downloads: | 426 |
|---|
| Metadata: |    |
|---|
|
:
|
Copy citation |
|---|
| | | | Share: |  |
|---|
Hover the mouse pointer over a document title to show the abstract or click
on the title to get all document metadata. |
