| Naslov: | Properties of the fluoroacrylate and methacryloxypropyl-trimethoxysilane applied to a layer of Cu2O on bronze as either single or multi-component coatings |
|---|
| Avtorji: | ID Škrlep, Luka (Avtor)
ID Kosec, Tadeja (Avtor)
ID Finšgar, Matjaž (Avtor)
ID Sever Škapin, Andrijana (Avtor)
ID Švara Fabjan, Erika (Avtor) |
|---|
| Datoteke: |  URL - Izvorni URL, za dostop obiščite https://www.sciencedirect.com/science/article/pii/S030094402300036X?via%3Dihub
 PDF - Predstavitvena datoteka, prenos (8,49 MB)
MD5: DDF83D7096F5DFE51E97857CAF7825ED
|
|---|
| Jezik: | Angleški jezik |
|---|
| Tipologija: | 1.01 - Izvirni znanstveni članek |
|---|
| Organizacija: |  ZAG - Zavod za gradbeništvo Slovenije
|
|---|
| Povzetek: | Various coatings have been developed and explored to protect bronze surfaces against the uncontrolled formation of different corrosion products when exposed to outdoor environments.
In this research, the surfaces of artificially-formed oxidized bronze patinas (OB), consisting of Cu2O, were covered with either a single-component (fluoroacrylate, FA or methacryloxypropyl-trimethoxysilane, MS) or multi-component (a mixture of FA and MS, FA-MS) fluoropolymer coating and investigated. Variations in the concentration of each component in the coating were studied. Electrochemical tests were performed to determine the corrosion protection efficiency, followed by detailed surface analyses of the OBs, both uncoated and covered with single and multi-component coatings. A variety of investigative methods were used, including focused ion beam scanning electron microscopy (FIB-SEM), X-ray photoelectron spectroscopy (XPS), atomic force microscopy (AFM), and time-of-flight secondary ion mass spectrometry (ToF-SIMS).
The coating made from a combination of FA and MS resulted in a very high protection efficiency. Despite the increased hydrophilicity of the single MS component, however, it was shown to efficiently protect the oxidized bronze surface. The FA-MS systems showed high hydrophobicity, but no improvement was measured in the efficiency of the corrosion protection when it was compared to the coating that contained 10% MS. According to XPS and ToF-SIMS imaging, the FA component of the FA-MS coating was not present only on the uppermost surface of the coating but throughout the whole coating, which could affect its corrosion protection efficiency. |
|---|
| Ključne besede: | bronze, Cu2O layer on bronze, fluoropolymer coating, protection efficiency, surface spectroscopy |
|---|
| Status publikacije: | Objavljeno |
|---|
| Verzija publikacije: | Objavljena publikacija |
|---|
| Datum objave: | 04.02.2023 |
|---|
| Založnik: | Elsevier |
|---|
| Leto izida: | 2023 |
|---|
| Št. strani: | str. 1-10 |
|---|
| Številčenje: | Vol. 177, [article no.] 107440 |
|---|
| PID: | 20.500.12556/DiRROS-16324  |
|---|
| UDK: | 620.1/.2 |
|---|
| ISSN pri članku: | 1873-331X |
|---|
| DOI: | 10.1016/j.porgcoat.2023.107440 |
|---|
| COBISS.SI-ID: | 140722179 |
|---|
| Avtorske pravice: | © 2023 The Authors. Published by Elsevier B.V. |
|---|
| Opomba: | Nasl. z nasl. zaslona;
Opis vira z dne 6. 2. 2023;
|
|---|
| Datum objave v DiRROS: | 30.05.2023 |
|---|
| Število ogledov: | 826 |
|---|
| Število prenosov: | 401 |
|---|
| Metapodatki: |    |
|---|
|
:
|
Kopiraj citat |
|---|
| | | | Objavi na: |  |
|---|
Postavite miškin kazalec na naslov za izpis povzetka. Klik na naslov izpiše
podrobnosti ali sproži prenos. |
