Digitalni repozitorij raziskovalnih organizacij Slovenije

Izpis gradiva
A+ | A- | Pomoč | SLO | ENG

Naslov:Characterizing steel corrosion in different alkali-activated mortars
Avtorji:ID Gartner, Nina (Avtor)
ID Hren, Miha (Avtor)
ID Kosec, Tadeja (Avtor)
ID Legat, Andraž (Avtor)
Datoteke:URL URL - Izvorni URL, za dostop obiščite https://www.mdpi.com/1996-1944/14/23/7366
 
.pdf PDF - Predstavitvena datoteka, prenos (7,00 MB)
MD5: C32401C384EEE7CBC7ADCD6129559E27
 
Jezik:Angleški jezik
Tipologija:1.01 - Izvirni znanstveni članek
Organizacija:Logo ZAG - Zavod za gradbeništvo Slovenije
Povzetek:Alkali-activated materials (AAMs) present a promising potential alternative to ordinary Portland cement (OPC). The service life of reinforced concrete structures depends greatly on the corrosion resistance of the steel used for reinforcement. Due to the wide range and diverse properties of AAMs, the corrosion processes of steel in these materials is still relatively unknown. Three different alkali-activated mortar mixes, based on fly ash, slag, or metakaolin, were prepared for this research. An ordinary carbon-steel reinforcing bar was installed in each of the mortar mixes. In order to study the corrosion properties of steel in the selected mortars, the specimens were exposed to a saline solution in wet/dry cycles for 17 weeks, and periodic electrochemical impedance spectroscopy (EIS) measurements were performed. The propagation of corrosion damage on the embedded steel bars was followed using X-ray computed microtomography (XCT). Periodic EIS measurements of the AAMs showed different impedance response in individual AAMs. Moreover, these impedance responses also changed over the time of exposure. Interpretation of the results was based on visual and numerical analysis of the corrosion damages obtained by XCT, which confirmed corrosion damage of varying type and extent on steel bars embedded in the tested AAMs.
Ključne besede:corrosion, alkali-activated mortars, steel reinforcement, electrochemical impedance spectroscopy, X-ray computed microtomography, visual analysis
Status publikacije:Objavljeno
Verzija publikacije:Objavljena publikacija
Datum objave:30.11.2021
Založnik:Molecular Diversity Preservation International
Leto izida:2021
Št. strani:str. 1-14
Številčenje:Vol. 14, iss. 23
PID:20.500.12556/DiRROS-16102 Novo okno
UDK:620.1/.2
ISSN pri članku:1996-1944
DOI:10.3390/ma14237366 Novo okno
COBISS.SI-ID:88913923 Novo okno
Avtorske pravice:© 2021 by the authors. Licensee MDPI, Basel, Switzerland.
Opomba:Nasl. z nasl. zaslona; Opis vira z dne 10. 12. 2021; Št. članka 7366;
Datum objave v DiRROS:05.07.2023
Število ogledov:730
Število prenosov:365
Metapodatki:XML DC-XML DC-RDF
:
Kopiraj citat
  
Objavi na:Bookmark and Share


Postavite miškin kazalec na naslov za izpis povzetka. Klik na naslov izpiše podrobnosti ali sproži prenos.

Gradivo je del revije

Naslov:Materials
Skrajšan naslov:Materials
Založnik:Molecular Diversity Preservation International
ISSN:1996-1944
COBISS.SI-ID:33588485 Novo okno

Gradivo je financirano iz projekta

Financer:ARRS - Agencija za raziskovalno dejavnost Republike Slovenije
Številka projekta:P2-0273
Naslov:Gradbeni objekti in materiali

Licence

Licenca:CC BY 4.0, Creative Commons Priznanje avtorstva 4.0 Mednarodna
Povezava:http://creativecommons.org/licenses/by/4.0/deed.sl
Opis:To je standardna licenca Creative Commons, ki daje uporabnikom največ možnosti za nadaljnjo uporabo dela, pri čemer morajo navesti avtorja.

Sekundarni jezik

Jezik:Slovenski jezik
Ključne besede:korozija, alkalijsko-aktivirane malte, armaturno jeklo, elektrokemijska impedančna spektroskopija, rentgenska računalniška mikrotomografija, vizualna analiza


Nazaj