Digitalni repozitorij raziskovalnih organizacij Slovenije

Iskanje po repozitoriju
A+ | A- | Pomoč | SLO | ENG

Iskalni niz: išči po
išči po
išči po
išči po

Možnosti:
  Ponastavi


Iskalni niz: "avtor" (Aleš Žnidarič) .

11 - 12 / 12
Na začetekNa prejšnjo stran12Na naslednjo stranNa konec
11.
Model updating concept using bridge Weigh-in-Motion data
Doron Hekič, Andrej Anžlin, Maja Kreslin, Aleš Žnidarič, Peter Češarek, 2023, izvirni znanstveni članek

Povzetek: Finite element (FE) model updating of bridges is based on the measured modal parameters and less frequently on the measured structural response under a known load. Until recently, the FE model updating did not consider strain measurements from sensors installed for weighing vehicles with bridge weigh-in-motion (B-WIM) systems. A 50-year-old multi-span concrete highway viaduct, renovated between 2017 and 2019, was equipped with continuous monitoring system with over 200 sensors, and a B-WIM system. In the most heavily instrumented span, the maximum measured longitudinal strains induced by the full-speed calibration vehicle passages were compared with the modelled strains. Based on the sensitivity study results, three variables that affected its overall stiffness were updated: Young’s modulus adjustment factor of all structural elements, and two anchorage reduction factors that considered the interaction between the superstructure and non-structural elements. The analysis confirmed the importance of the initial manual FE model updating to correctly reflect the non-structural elements during the automatic nonlinear optimisation. It also demonstrated a successful use of pseudo-static B-WIM loading data during the model updating process and the potential to extend the proposed approach to using random B-WIM-weighed vehicles for FE model updating and long-term monitoring of structural parameters and load-dependent phenomena.
Ključne besede: monitoring, bridge, viaduct, bridge weigh-in-motion (B-WIM), structural health monitoring (SHM), finite element (FE), calibration, model updating
Objavljeno v DiRROS: 29.05.2023; Ogledov: 422; Prenosov: 227
.pdf Celotno besedilo (26,28 MB)
Gradivo ima več datotek! Več...

12.
Development and testing of a railway bridge weigh-in-motion system
Donya Hajializadeh, Aleš Žnidarič, Jan Kalin, Eugene J. OBrien, 2020, izvirni znanstveni članek

Povzetek: This study describes the development and testing of a railway bridge weigh-in-motion (RB-WIM) system. The traditional bridge WIM (B-WIM) system developed for road bridges was extended here to calculate the weights of railway carriages. The system was tested using the measured response from a test bridge in Poland, and the accuracy of the system was assessed using statically-weighed trains. To accommodate variable velocity of the trains, the standard B-WIM algorithm, which assumes a constant velocity during the passage of a vehicle, was adjusted and the algorithm revised accordingly. The results showed that the vast majority of the calculated carriage weights fell within %5% of their true, statically-weighed values. The sensitivity of the method to the calibration methods was then assessed using regression models, trained by di%erent combinations of calibration trains.
Ključne besede: bridge weigh-in-motion, railway bridge loading, bridge instrumentation, B-WIM
Objavljeno v DiRROS: 22.05.2023; Ogledov: 320; Prenosov: 155
.pdf Celotno besedilo (6,18 MB)
Gradivo ima več datotek! Več...
Iskanje izvedeno v 0.09 sek.
Na vrh