31. |
32. |
33. Water versus oil lubrication of laser-textured Ti6Al4V alloy upon addition of MoS2 nanotubes for green tribologyMarjetka Conradi, Bojan Podgornik, Aleksandra Kocijan, Maja Remškar, Damjan Klobčar, 2022, izvirni znanstveni članek Ključne besede: green tribology, surface texturing, MoS2 nanotubes, lubrication, Ti6Al4V alloy Objavljeno v DiRROS: 06.05.2022; Ogledov: 658; Prenosov: 211
Povezava na datoteko |
34. |
35. Effect of surface oxidation on oxidative propane dehydrogenation over chromia : ǂan ǂab initio multiscale kinetic studyMatej Huš, Drejc Kopač, David Bajec, Blaž Likozar, 2021, izvirni znanstveni članek Ključne besede: dehydrogenation, chromium oxide, surface oxidation, propane, multiscale modeling Objavljeno v DiRROS: 03.09.2021; Ogledov: 1244; Prenosov: 922
Celotno besedilo (4,46 MB) Gradivo ima več datotek! Več... |
36. The influence of land use on the spatial distribution and intensity of heat islands in SloveniaAnica Simčič, Petra Pečan, Mojca Nastran, Milan Kobal, 2021, izvirni znanstveni članek Povzetek: Heat islands (HI) are a common anthropogenic phenomenon and are defined as artificial surfaces (urban areas) that have a higher average temperature than their surroundings (rural areas). The aim of this work was to determine the influence of land use on the spatial distribution and intensity (HIi ) of HI in Slovenia. The MODIS Land Surface Temperature (LST) and Corine Land Cover (CLC) databases were used to perform the analysis. Within the identified HI, two HI levels were determined based on temperature difference. The results revealed a statistically significant negative correlation between HIi and both forest co%ver and forest fragmentation (forest edge density and ratio of mean forest patch size to HI size). Artificial surface was positively correlated with HIi . The results contribute to the understanding of the spatial distribution of HI and HIi and provide informati%on for spatial planning and policy-making to reduce the negative impact of HI. Ključne besede: heat island, forest cover, artificial surface, forest fragmentation Objavljeno v DiRROS: 17.08.2021; Ogledov: 3759; Prenosov: 2202
Celotno besedilo (1011,73 KB) Gradivo ima več datotek! Več... |
37. Influence of drying temperature on properties of wood surfacesMilan Šernek, 2002, izvirni znanstveni članek Povzetek: This article deals with modifications of wood surface properties induced by different drying temperatures. The aim of the study was chemical and physical characterization of a wood surface concerning low and high temperature exposure. Additionally, the correlation between the chemical composition of a wood surface and its wetting capacity were investigated. X-ray photoelectron spectroscopy and contact angle measurements were conducted. Two wood species, yellow poplar (Liriodendron tulipifera) and southern pine (Pinus taeda) were studied. The results showed that the percentage of carbon increased with drying temperature, and consequently, the percentage of oxygen decreased. The samples exposed to high drying temperatures indicated a higher content of extractives on the wood surface. These samples exhibited the highest contact angle and the lowest wettability Ključne besede: površina lesa, sušenje, kontaktni kot, rentgenska fotoelektronska spektroskopija, omočitev, ekstraktivne snovi, wood surface, drying, contact angle, XPS, wettability, extractives Objavljeno v DiRROS: 12.07.2017; Ogledov: 4858; Prenosov: 1994
Celotno besedilo (932,44 KB) |