31. Cost-benefit analysis in fire safety engineering : state-of-the-art and reference methodologyRuben Van Coile, Andrea Lucherini, Ranjit Kumar Chaudhary, Shuna Ni, David Unobe, Thomas Gernay, 2023, izvirni znanstveni članek Povzetek: Cost-effectiveness is a key consideration within fire safety engineering. Currently, different approaches are being applied in literature. These approaches differ in how cost-effectiveness is evaluated, which costs are considered, and how the preferred design solution is defined. Recognizing this issue, the Fire Protection Research Foundation enrolled an international team of researchers, supported by a broad stakeholder panel, to develop a reference methodology. In this paper, this reference methodology for cost-benefit analysis in fire safety engineering is presented following an extensive literature review. The methodology clarifies the minimum requirements for assessing cost-effectiveness, and highlights that only a present net value evaluation can be used to compare design alternatives. Commonly used cost-benefit ratios should only be used when deciding on the effectiveness of a single package of fire safety measures. An illustrative case study demonstrates the application of the meth- odology and shows how designs based on cost-benefit ratios can be sub-optimal when evaluating multiple possible fire safety measures.
Ključne besede: cost-benefit analysis, fire safety, investment, maintenance, loss, statistics, reliability
Objavljeno v DiRROS: 23.10.2023; Ogledov: 385; Prenosov: 90
 Povezava na datoteko
Gradivo ima več datotek! Več... |
32. |
33. Social innovation to address sustainability challenges and enlarge the opportunities provided by forests for a green and just transition of marginalised mountain areasMaria Nijnik, Simo Sarkki, Mariana Melnykovych, David Miller, 2023, objavljeni znanstveni prispevek na konferenci (vabljeno predavanje) Ključne besede: natural capital, ecosystem services, woodlands, communities, stakeholder engagement, sustainability, resilience
Objavljeno v DiRROS: 04.10.2023; Ogledov: 397; Prenosov: 110
 Celotno besedilo (539,85 KB) |
34. Developing and assessing surveillance methodologies for Agrilus beetles : EuphrescoDavid Williams, Abigail Enston, Joseph A. Francese, Damon Crook, Gernot Hoch, Maarten De Groot, 2023, končno poročilo o rezultatih raziskav Ključne besede: Agrilus, beetles, developing surveillance, assessing surveillance
Objavljeno v DiRROS: 18.09.2023; Ogledov: 497; Prenosov: 157
Celotno besedilo (2,92 MB)
Gradivo ima več datotek! Več... |
35. Chemical recycling of flexible polyurethane foams by aminolysis to recover high-quality polyolsMaja Grdadolnik, Blaž Zdovc, Ana Drinčić, Özgün Can Önder, Petra Utroša, Susana Garcia Ramos, Enrique Dominguez Ramos, David Pahovnik, Ema Žagar, 2023, izvirni znanstveni članek Objavljeno v DiRROS: 28.08.2023; Ogledov: 390; Prenosov: 180
Celotno besedilo (1,37 MB)
Gradivo ima več datotek! Več... |
36. |
37. Sustainable biocarbon/tung oil coatings with hydrophobic and UV-shielding properties for outdoor wood substratesLaetitia Sarah Jennifer Marrot, Mariem Zouari, Matthew Schwarzkopf, David Brian DeVallance, 2023, izvirni znanstveni članek Povzetek: With wood regaining substantial interest as a construction material due to sustainability concerns and aesthetics trends, efficient and safe protection methods are needed to prevent the discouloration and the loss of mechanical properties of this renewable and UV-sensitive material. In this study, sustainable coatings comprising 0 to 20 wt % biocarbon (BC) dispersed in tung oil were developed for wood protection. BC particles were added as ultraviolet (UV) absorbers and were produced by various carbonization routes. The BC powders were characterized in terms of particle size and surface functional groups by Fourier-Transform infrared, and the UV and visible absorbance of dispersed BC powders in water solutions were related to these characteristics.
Two wooden substrates (beech and oak) were coated with the developed coatings and the samples underwent six months of onsite weathering. While the total colour change of uncoated samples and tung oil-coated substrates without BC kept increasing over time and resulted in a clear alteration of the wood surface aesthetics, an increased BC content in the coatings led to enhanced colour stability, with alteration of the colour close to 2 for both wood species after six months of weathering for 10 and 20 wt% BC.
Coating with tung oil made the wooden substrates, initially hydrophilic, become hydrophobic, and the further introduction of biocarbon increased hydrophobicity. However, the increase in BC content was not correlated with an increase in water repellence, the highest water contact angle being observed for 5 % BC, and no further improvement in hydrophobicity was observed with higher BC content. The weathering negatively affected the water repellence of all the samples (i.e., reference samples and coated samples with various BC content). However, the introduction of 20 % BC best protected the decrease in water repellence induced by the onsite weathering.
Ključne besede: biocarbon, biochar, coating, wood protection, hydrophobic coating, wettability
Objavljeno v DiRROS: 30.05.2023; Ogledov: 383; Prenosov: 442
Celotno besedilo (6,19 MB)
Gradivo ima več datotek! Več... |
38. Application of electrochemical methods for studying steel corrosion in alkali-activated materialsShishir Mundra, Gabriel Samson, Giulia Masi, Rebecca Achenbach, David M. Bastidas, Susana Bernal, Maria Chiara Bignozzi, Maria Criado, Martin Cyr, Nina Gartner, Stefanie von Greve‐Dierfeld, Andraž Legat, Nikoonasab Ali, John L. Provis, Michael Raupach, Gregor J. G. Gluth, 2023, izvirni znanstveni članek Povzetek: Alkali‐activated materials (AAMs) are binders that can complement and partially substitute the current use of conventional cement. However, the present knowledge about how AAMs protect steel reinforcement in concrete elements is incomplete, and uncertainties exist regarding the application of electrochemical methods to investigate this issue. The present review by EFC WP11‐Task Force ‘Corrosion of steel in alkali‐activated materials’ demonstrates that important differences exist between AAMs and Portland cement, and between different classes of AAMs, which are mainly caused by differing pore solution compositions, and which affect the outcomes of electrochemical measurements. The high sulfide concentrations in blast furnace slag‐based AAMs lead to distinct anodic polarisation curves, unusually low open circuit potentials, and low polarisation resistances, which might be incorrectly interpreted as indicating active corrosion of steel reinforcement. No systematic study of the influence of the steel–concrete interface on the susceptibility of steel to corrosion in AAMs is available. Less common electrochemical methods present an opportunity for future progress in the field.
Ključne besede: alkali-aktivated materials, alkali‐activated materials, anodic/cathodic polarisation, concrete, linear polarisation resistance, open circuit potential, reinforcement corrosion, resistivity
Objavljeno v DiRROS: 29.05.2023; Ogledov: 359; Prenosov: 147
Povezava na datoteko
Gradivo ima več datotek! Več... |
39. Mode I fracture of beech-adhesive bondline at three different temperaturesJaka Gašper Pečnik, Andreja Pondelak, Michael David Burnard, Václav Sebera, 2022, izvirni znanstveni članek Povzetek: Single edge-notched three-point bending tests (SEN-TPB) for mode I were utilized to experimentallyevaluate fracture properties of adhesive bondlines in European beech (Fagus SylvaticaL.). Thebondline was examined at two anatomical planes with TR and RT orientation and at control andtwo elevated temperatures (70°C and 140°C). Among epoxy (EPI), melamine-urea formaldehyde (MUF), and polyurethane (PUR) adhesives, the highest average critical energyGcwith 0.80 N/mmand fracture energyGfwith 1079.4 N/mm were obtained for EPI in the TR plane and understandard climate conditions (20°C/65% relative humidity), followed by MUF (Gc= 0.50 N/mm andGf= 620 N/mm) and PUR (Gc= 0.25 N/mm andGf= 290.9 N/mm), respectively. PUR was leasteffected by elevated temperature, and no significant differences forGcandGfbetween TR and RTbondline orientations were found for MUF and PUR treated at 20°C/65% relative humidity whilecomparisons between other factors varied significantly. Treatment of specimens at elevatedtemperatures resulted in reduced fracture performance regardless of wood grain orientation orthe adhesive system.
Ključne besede: crack, fracture, grain orientation, temperature, European Beech, odprti dostop
Objavljeno v DiRROS: 03.05.2023; Ogledov: 486; Prenosov: 380
Celotno besedilo (3,32 MB)
Gradivo ima več datotek! Več... |
40. Multiscale femoral neck imaging and multimodal trabeculae quality characterization in an osteoporotic bone sampleEnrico Soldati, Flavy Roseren, Daphne Guenoun, Lucia Mancini, Emilio Catelli, Silvia Prati, Giorgia Sciutto, Jerome Vicente, Stefano Iotti, David Bendahan, Emil Malucelli, Martine Pithioux, 2022, izvirni znanstveni članek Povzetek: Although multiple structural, mechanical, and molecular factors are definitely involved in osteoporosis, the assessment of subregional bone mineral density remains the most commonly used diagnostic index. In this study, we characterized bone quality in the femoral neck of one osteoporotic patients as compared to an age-matched control subject, and so used a multiscale and multimodal approach including X-ray computed microtomography at different spatial resolutions (pixel size: 51.0, 4.95 and 0.9 µm), microindentation and Fourier transform infrared spectroscopy. Our results showed abnormalities in the osteocytes lacunae volume (358.08 ± 165.00 for the osteoporotic sample vs. 287.10 ± 160.00 for the control), whereas a statistical difference was found neither for shape nor for density. The osteoporotic femoral head and great trochanter reported reduced elastic modulus (Es) and hardness (H) compared to the control reference (−48% (p < 0.0001) and −34% (p < 0.0001), respectively for Es and H in the femoral head and −29% (p < 0.01) and −22% (p < 0.05), respectively for Es and H in the great trochanter), whereas the corresponding values in the femoral neck were in the same range. The spectral analysis could distinguish neither subregional differences in the osteoporotic sample nor between the osteoporotic and healthy samples. Although, infrared spectroscopic measurements were comparable among subregions, and so regardless of the bone osteoporotic status, the trabecular mechanical properties were comparable only in the femoral neck. These results illustrate that bone remodeling in osteoporosis is a non-uniform process with different rates in different bone anatomical regions, hence showing the interest of a clear analysis of the bone microarchitecture in the case of patients’ osteoporotic evaluation
Ključne besede: synchrotron X-ray microtomography, bone, trabecular struicture, osteons, osteoporosis, phase-contrast imaging, open access
Objavljeno v DiRROS: 28.04.2023; Ogledov: 426; Prenosov: 207
Celotno besedilo (4,87 MB)
Gradivo ima več datotek! Več... |
