Digital repository of Slovenian research organisations

Search the repository
A+ | A- | Help | SLO | ENG

Query: search in
search in
search in
search in

Options:
  Reset


Query: "author" (Miha %C4%8Cavlek) .

1 - 10 / 293
First pagePrevious page12345678910Next pageLast page
1.
2.
3.
An investigation into corrosion around voids at the steel-concrete interface
Miha Hren, Tadeja Kosec, Andraž Legat, 2024, original scientific article

Abstract: In this study, the influence of voids on corrosion process at the steel-concrete interface was investigated, as the exact influence of these features on corrosion processes under various environmental conditions is not entirely understood. Coupled multi electrode arrays and electrical resistance probes were implemented to monitor the evolution of corrosion under cyclic exposure to chlorides and carbonation. MicroCT was used to determine the location and volume of corrosion damage. It was found that, in most cases, corrosion damage initiated outside the voids. During initiation and the early propagation phase, the steel beneath the voids rarely participated in the redox reaction. In following phases, various kinds of corrosion evolution were observed. Specific corrosion mechanisms were proposed and discussed to explain these corrosion processes.
Keywords: microtomography, corrosion, coupled multi-electrode array, steel-concrete interface
Published in DiRROS: 06.06.2024; Views: 65; Downloads: 62
.pdf Full text (23,73 MB)
This document has many files! More...

4.
Gozd in les : podnebne spremembe in biotska raznolikost: znanstveno srečanje
2024, proceedings of peer-reviewed scientific conference contributions (domestic conferences)

Published in DiRROS: 29.05.2024; Views: 167; Downloads: 107
.pdf Full text (2,03 MB)

5.
Susceptibility of X17CrNi16-2 martensitic stainless steel to hydrogen embrittlement after conventional and deep cryogenic heat treatment
Mirjam Bajt Leban, Bojan Zajec, Bojan Podgornik, Črtomir Donik, Patricia Jovičević Klug, Miha Hren, Andraž Legat, 2024, original scientific article

Abstract: A low carbon/ high chromium martensitic stainless steel, X17CrNi16-2, was heat treated using two different hardening and tempering regimes (1050 ◦ C/480 ◦ C or 980 ◦C/600 ◦C) — promoting either a high strength or high toughness state, respectively and further combined with deep cryogenic treatment (DCT) at 196 ◦C for 24 h. Over recent years DCT has been recognized as a promising technique to improve the properties of steel, predominantly with respect to its tensile strength, toughness and wear resistance. The influence of DCT on the hydrogen embrittlement resistance of martensitic stainless steel has not yet, however, been reported. A slow strain rate tensile test (SSRT) with simultaneous cathodic hydrogen charging was selected as the method to assess potential susceptibility to hydrogen embrittlement (HE). Relatively low-intensity hydrogen charging, utilizing a constant current density of 0.1 mA/cm2, in a non-corrosive, slightly alkaline buffer solution, led to a clear reduction in the ultimate tensile stress. This reduction, and therefore the HE susceptibility, was more pronounced in the steel with a higher strength (i.e. that subject to the 1050 ◦C/ 480 ◦C heat treatment condition). Furthermore, DCT did not appear to have any impact on the steel’s mechanical properties in the presence of hydrogen. Fractographic analysis showed clear evidence of HE in the hydrogen-charged specimens. This paper presents results of the SSRT tests and further fractography results, and discusses the impact of conventional and deep cryogenic treatment on HE susceptibility.
Keywords: martensitic stainless steel, deep cryogenic treatment, hydrogen embrittlement, slow strain rate tensile test
Published in DiRROS: 23.05.2024; Views: 117; Downloads: 130
.pdf Full text (17,73 MB)
This document has many files! More...

6.
7.
Etični kodeksi, konvencije in načela
Miha Oražem, 2024, independent scientific component part or a chapter in a monograph

Keywords: onkologija, etika, klinične raziskave
Published in DiRROS: 24.04.2024; Views: 169; Downloads: 38
.pdf Full text (170,09 KB)

8.
9.
Identification of three anatomical patterns of the spinal accessory nerve in the neck by neurophysiological mapping
Boštjan Lanišnik, Miha Žargi, Zoran Rodi, 2014, original scientific article

Abstract: Background. In spite of preservation of the accessory nerve there is still considerable proportion of patients with partial nerve damage during modified radical neck dissection (MRND). Methods. The nerve was identified during the surgery and its branches for the trapezius muscle mapped with nerve monitor. Results. The accessory nerve was mapped during 74 hemineck dissections and three patterns were identified. In type 1 nerve exits at the posterior end of the sternocleidomastoid muscle (SCm) and then it enters the level V (66 %). In type 2 the nerve for trapezius muscle branches off before entering the SCm (22 %). In type 3 the nerve exits at the posterior part of the SCm and it joins to the cervical plexus (12 %). The nerve than exits this junction more medially as a single trapezius branch. Conclusions. The description of three anatomical patterns in level II and V could help preserving the trapezius branch during MRND.
Keywords: spinal accessory nerve, nerve mapping, neck dissection, anatomy, shoulder disability
Published in DiRROS: 11.04.2024; Views: 477; Downloads: 327
.pdf Full text (1,66 MB)
This document has many files! More...

10.
Search done in 0.35 sec.
Back to top