1. |
2. |
3. |
4. Apparatus for positron emission tomographyMarko Starič, Samo Korpar, Erik Margan, Marko Šifrar, Aleš Stanovnik, Nataša Budihna, Metka Milčinski, Boris Šket, 1998, original scientific article Published in DiRROS: 19.01.2024; Views: 143; Downloads: 37 Full text (693,52 KB) |
5. Phase II study of fluorouracil, leucovorin and interferon alpha-2a in patients with advanced colon cancerBorut Štabuc, Aleksandra Markovič, Erik Brecelj, Samir Bešlija, Tomaž-Edvard Cizej, 1998, original scientific article Abstract: Based on in viro studies that have demonstrated synergy between fluorouracil (5-FU) and leucovorin (LV) as well as between 5-FU and recombinant alpha-2a interferon (IFN) against colon cancer cell lines a phase II study was carried out to evaluate the toxicity and clinical activity of 5-FU modulated with LV and IFN in patients with metastatic colon cancer. Twenty-two chemotherapy naive patients with measurable metastases of colon cancer have been treated with daily doses of 5-FU 600 mg/m2 in 6-hr intravenous infusion, and of LV 20 mg/m2 intravenously and IFN 6 MU subcutaneously, for 5 days every 4 weeks. Median age was 60 years, median PS (ECOG) was 1 (range 0-2). Liver, soft tissue and lung metastases were found in 12, 5 and 8 patients, respectively. Nineteen patients had a single metastatic site, two double, whereas one had more than two metastatic sites. Patients had 2-9 (mean 5) cycles of treatment.Objective response was observed in 7 patients (32%), and stable disease in 7 patients (32%). Overall median survival was 12.5 months, and for responders 14.4 months. Responses were generally short and median time for progression was 5.5 months. The most frequent adverse reactions were flu-like syndrome (50%), nausea/vomiting (36%), diarhoea (13Č), stomatitis (27%) and leucopenia (13%). This regimen of 5-FU with LV and IFN administration does notappear to be superior to previously published shedules of 5-FU with IFN or 5-FU with LV. Published in DiRROS: 19.01.2024; Views: 135; Downloads: 40 Full text (430,62 KB) |
6. Coastal flood risk assessment : an approach to accurately map flooding through national registry-reported eventsErik Kralj, Peter Kumer, Cécil J. W. Meulenberg, 2023, original scientific article Keywords: sea flood prediction, flooding maps, climate change resilience, natural disaster registry, coastal inundation, flood-prone areas Published in DiRROS: 08.12.2023; Views: 209; Downloads: 93 Full text (7,60 MB) This document has many files! More... |
7. Experimental investigation of the axial strength of glued-in rods in cross laminated timberBoris Azinović, Erik Serrano, Miha Kramar, Tomaž Pazlar, 2018, original scientific article Abstract: This paper presents results from an experimental assessment of glued-in rods in cross laminated timber (CLT). For the purposes of the study more than 60 pull-pull tests were performed, where the specimens varied in terms of bonded-in length (from 80 to 400 mm), rod diameter (16-24 mm) and rod-to-grain angle (parallel and perpendicular). Several different failure modes that are not common for other applications of glued-in rods (e.g., a failure between CLT layers) were obtained for the analysed CLT specimens. It was found that these failure mechanisms can substantially influence the obtained ultimate tension loads. At the end, the experimental results were compared with empirical and semi-empirical equations for estimating the pull-out strength of glued-in rods in structural timber and glulam. The comparison showed that most of the existing equations overestimate the ultimate tension loads for specimens with the rod parallel to the grain and underestimate the ultimate tension load for specimens with the rod perpendicular to the grain. The results vary because the possible CLT failure modes were not included in previous studies. Further studies are proposed to improve the equations for glued-in rods in CLT. Keywords: glued-in rods, cross laminated timber (CLT), pull-pull experiment, glued-in length, rod-to-grain angle, failure mechanisms in CLT Published in DiRROS: 29.11.2023; Views: 181; Downloads: 142 Full text (4,13 MB) This document has many files! More... |
8. |
9. Forest genetic resources and forest reproductive material at the crosssection of multiple policy domains in EuropeTodora Rogelja, Laura Secco, Aurelio Padovezi, Davide Pettenella, Mauro Masiero, Elena Pisani, Jacopo Giacomoni, Riccardo Da Re, Sofia Caiolo, Marko Lovrić, Anna-Maria Farsakoglou, Michele Bozzano, François Lefèvre, Bruno Fady, Aurore Desgroux, Santiago C. González-Martínez, Ulla Ovaska, Mari Rusanen, Egbert Beuker, Katriina Soini, Anže Japelj, Konrad Heino, Martin Braun, Erik Dahl Kjær, Jon Kehlet Hansen, Georgeta Mihai, Alin Alexandru, Ecaterina-Nicoleta Apostol, Alicia Fernandez Calvo, Laura Maria Luquero Ramos, Mariano Navarro De La Cruz, Giovanna Ottaviani Aalmo, Bent Leonhard, 2023, published scientific conference contribution Keywords: forest genetic diversity, forest biodiversity, sustainable forest management, policy gap analysis, forest genetic resources, forest reproductive material Published in DiRROS: 05.10.2023; Views: 384; Downloads: 110 Full text (113,21 KB) |
10. Glued-in rods in cross laminated timber - numerical simulations and parametric studiesBoris Azinović, Henrik Danielsson, Erik Serrano, Miha Kramar, 2019, original scientific article Abstract: Numerical simulations and parametric studies of glued-in rods in cross-laminated timber have been performed. The simulations were based on 3D finite element analysis, using a cohesive surface model for the bond-lines between the laminations and the bond-line along the rod. The parametric studies investigated the influence of the glued-in length, the rod diameter, and the rod-to-grain angle on the load-bearing capacity and stiffness of the connection. The analyses showed that the load-bearing capacity generally increases with the glued-in length and the rod diameter, which agrees well with experiments. For different rod-to-grain angles, different mechanical behaviour was observed, especially considering the failure modes. Keywords: glued-in rods, cross laminated timber (CLT), parametric study, nonlinear numerical modelling, glued-in length, rod diameter, rod orientation Published in DiRROS: 13.09.2023; Views: 220; Downloads: 126 Full text (2,66 MB) This document has many files! More... |