Digitalni repozitorij raziskovalnih organizacij Slovenije

Iskanje po repozitoriju
A+ | A- | Pomoč | SLO | ENG

Iskalni niz: išči po
išči po
išči po
išči po

Možnosti:
  Ponastavi


Iskalni niz: "avtor" (Josef Fr%C3%BDdl) .

1 - 10 / 11
Na začetekNa prejšnjo stran12Na naslednjo stranNa konec
1.
2.
The impact of silicon on the solidification of duplex lightweight steels
Tilen Balaško, Jaka Burja, Jože Medved, 2023, izvirni znanstveni članek

Ključne besede: lightweight steels, duplex steels, solidifcation, DTA, CALPHAD
Objavljeno v DiRROS: 02.02.2024; Ogledov: 148; Prenosov: 49
.pdf Celotno besedilo (961,71 KB)
Gradivo ima več datotek! Več...

3.
4.
5.
Comparison of cycling high temperature corrosion at 650°C in the presence of NaCl of various austenitic stainless steels
Mirjam Bajt Leban, Maja Vončina, Tadeja Kosec, Robert Tisu, Matevž Barborič, Jože Medved, 2023, izvirni znanstveni članek

Povzetek: The high temperature corrosion at 650°C in the presence of NaCl at atmospheric pressure of AISI 304L, AISI 309, AISI 310S, AISI 314 and AISI 321 austenitic stainless steel was studied. The specimens were cyclically heated in the furnace and immersed in a 3.5% aqueous NaCl solution after cooling for 15 min. After each cycle, the change in mass of the samples was measured. The corroded samples were analysed by SEM /EDX, and the corrosion products were analysed by XRD. The chloride ions react with the steel surface to form porous and poorly adherent oxides and metal chlorides. After the mass increase during the first exposure cycles, spalling of the oxides occurred. The high temperature austenitic stainless steels (AISI 309, AISI 310S, AISI 314) showed less mass loss than conventional austenitic steels (AISI 304L). Surprisingly, the stainless steel AISI 321 showed a similar low weight loss after the cyclic test as AISI 309, but a detailed analysis of the exposed surfaces after the test showed a similar corrosion attack as for AISI 304. After the cyclic test at high temperature in the presence of NaCl, a higher concentration of Cr and Ni definitely improves the corrosion resistance under the present conditions, but a certain addition of Si is even more obvious.
Ključne besede: austenitic stainless steel, high temperature corrosion, NaCl, exhaust systems, open access
Objavljeno v DiRROS: 31.05.2023; Ogledov: 246; Prenosov: 161
.pdf Celotno besedilo (1,53 MB)
Gradivo ima več datotek! Več...

6.
First report of Erysiphe corylacearum on Corylus avellana and C. colurna in Slovenia
Janja Zajc, Mojca Rot, David Snoj, Metka Žerjav, Hans-Josef Schroers, Barbara Piškur, Nikica Ogris, Ana Brglez, 2023, kratki znanstveni prispevek

Ključne besede: common hazel, Turkish hazel, powdery mildew
Objavljeno v DiRROS: 28.02.2023; Ogledov: 498; Prenosov: 185
.pdf Celotno besedilo (258,92 KB)
Gradivo ima več datotek! Več...

7.
Diversity, migration routes, and worldwide population genetic structure of Lecanosticta acicola, the causal agent of brown spot needle blight
Marili Laas, Kalev Adamson, Irene Barnes, Josef Janoušek, Martin S. Mullett, Katarína Adamčíková, Mitsuteru Akiba, Ludwig Beenken, Helena Bragança, Timur S. Bulgakov, Barbara Piškur, 2022, izvirni znanstveni članek

Povzetek: Lecanosticta acicola is a pine needle pathogen causing brown spot needle blight that results in premature needle shedding with considerable damage described in North America, Europe, and Asia. Microsatellite and mating type markers were used to study the population genetics, migration history, and reproduction mode of the pathogen, based on a collection of 650 isolates from 27 countries and 26 hosts across the range of L. acicola. The presence of L. acicola in Georgia was confirmed in this study. Migration analyses indicate there have been several introduction events from North America into Europe. However, some of the source populations still appear to remain unknown. The populations in Croatia and western Asia appear to originate from genetically similar populations in North America. Intercontinental movement of the pathogen was reflected in an identical haplotype occurring on two continents, in North America (Canada) and Europe (Germany). Several shared haplotypes between European populations further suggests more local pathogen movement between countries. Moreover, migration analyses indicate that the populations in northern Europe originate from more established populations in central Europe. Overall, the highest genetic diversity was observed in south-eastern USA. In Europe, the highest diversity was observed in France, where the presence of both known pathogen lineages was recorded. Less than half of the observed populations contained mating types in equal proportions. Although there is evidence of some sexual reproduction taking place, the pathogen spreads predominantly asexually and through anthropogenic activity.
Ključne besede: brown spot needle blight, Lecanosticta acicola, pones, Pinus spp., popularion structure
Objavljeno v DiRROS: 12.08.2022; Ogledov: 557; Prenosov: 274
.pdf Celotno besedilo (3,06 MB)
Gradivo ima več datotek! Več...

8.
9.
Genetic aspects linked to production and use of forest reproductive material (FRM) : collecting scientific evidence for developing guidelines and decision support tools for effective FRM management
Dušan Gömöry, Katri Himanen, Mari Mette Tollefsrud, Claes Uggla, Hojka Kraigher, Sandor Bordacs, Paraskevi Alizoti, Stuart A'Hara, Aline Frank, Gunnar Friis Proschowsky, Josef Frýdl, Thomas Geburek, Monique Guibert, Mladen Ivanković, Ana Jurše, Stuart Kennedy, Jan Kowalczyk, Heike Liesebach, Tiit Maaten, Andrej Pilipović, Roberta Proietti, Volker Schneck, Alain Servais, Brynjar Skúlason, Christoph Sperisen, Frank Wolter, Tefide Yüksel, Michele Bozzano, 2021, slovar, enciklopedija, leksikon, priročnik, atlas, zemljevid

Povzetek: This report summarises the current state of knowledge in genetic aspects linked to the production and use of forest reproductive material (FRM). The first chapter describes the different categories of FRM, considers the strategic choice between artificial and natural regeneration in the face of climate change, and articulates the need for and purposes of FRM. Chapter 2 outlines the FRM production chain, in terms of: i) FRM approval, management, collection and certification (seed sources, stands, orchards, plus trees and clones others); ii) Testing standards and examples; iii) Effect of seed and seedling material not intended for use as FRM on forest genetic resources; iv) Breeding effects on basic material including conservation strategy; v) Harvesting, processing and storage of seeds; vi) Nursery practices; vii) Certification and Traceability; and viii) FRM Trading and Transport. Chapter 3 examines FRM with regard to: i) Forest regeneration strategies % especially considering climate change, and ii) Assisted migration and available decision support tools. Chapter 4 provides a detailed overview of forest establishment methods, and chapter 5 looks at keeping records of seed origin to improve forest management. The final chapter offers 38 recommendations arising from the review. This work is the result of an international collaboration rooted in EUFORGEN for more than two decades. It is built on the firm belief that the genetic element is decisive for the creation of a resilient forest capable of surviving threats and adapting to changes, thus enabling the evolution of ecosystems and the conservation of the productive landscape.
Ključne besede: forest reproductive material
Objavljeno v DiRROS: 05.11.2021; Ogledov: 804; Prenosov: 445
.pdf Celotno besedilo (5,81 MB)
Gradivo ima več datotek! Več...

10.
Surprising drought tolerance of Fir (Abies) species between past climatic adaptation and future projections reveals new chances for adaptive forest management
Csaba Mátyás, František Beran, Jaroslav Dostál, Jiří Čáp, Martin Fulín, Monika Vejpustková, Gregor Božič, Pál Balázs, Josef Frýdl, 2021, izvirni znanstveni članek

Povzetek: esearch Highlights: Data of advanced-age provenance tests were reanalyzed applying a new approach, to directly estimate the growth of populations at their original sites under individually generated future climates. The results revealed the high resilience potential of fir species. Background and Objectives: The growth and survival of silver fir under future climatic scenarios are insufficiently investigated at the xeric limits. The selective signature of past climate determining the current and projected growth was investigated to analyze the prospects of adaptive silviculture and assisted transfer of silver fir populations, and the introduction of non-autochthonous species. Materials and Methods: Hargreaves% climatic moisture deficit was selected to model height responses of adult populations. Climatic transfer distance was used to assess the relative drought stress of populations at the test site, relating these to the past conditions to which the populations had adapted. ClimateEU and ClimateWNA pathway RCP8.5 data served to determine individually past, current, and future moisture deficit conditions. Besides silver fir, other fir species from South Europe and the American Northwest were also tested. Results: Drought tolerance profiles explained the responses of transferred provenances and predicted their future performance and survival. Silver fir displayed significant within-species differentiation regarding drought stress response. Applying the assumed drought tolerance limit of 100 mm relative moisture deficit, most of the tested silver fir populations seem to survive their projected climate at their origin until the end of the century. Survival is likely also for transferred Balkan fir species and for grand fir populations, but not for the Mediterranean species. Conclusions: The projections are less dramatic than provided by usual inventory assessments, considering also the resilience of populations. The method fills the existing gap between experimentally determined adaptive response and the predictions needed for management decisions. It also underscores the unique potential of provenance tests.
Ključne besede: climate change, common garden, provenance test, silver fir, grand fir, Balkan firs, drought stress, resilience, climate transfer distance, adaptation
Objavljeno v DiRROS: 05.07.2021; Ogledov: 889; Prenosov: 565
.pdf Celotno besedilo (1,46 MB)
Gradivo ima več datotek! Več...

Iskanje izvedeno v 0.3 sek.
Na vrh