1. Why geopolymers and alkali-activated materials are key components of a sustainable world : a perspective contributionWaltraud M. Kriven, Cristina Leonelli, John L. Provis, Aldo R. Boccaccini, Cyril Attwell, Vilma Ducman, Claudio Ferone, Sylvie Rossignol, Tero Luukkonen, Jannie S. J. Van Deventer, José V. Emiliano, Jérôme E. Lombardi, 2024, izvirni znanstveni članek Povzetek: This perspective article delves into the transformative potential of alkali-activated materials, acid-activated materials, and geopolymers in mitigating climate change and market challenges. To harness the benefits of these materials, a comprehensive strategy is proposed. This strategy aims to integrate these materials into existing construction regulations, facilitate certification, and promote market access. Emphasizing research and innovation, the article advocates for, increased funding to refine the chemistry and production of these materials, prioritizing low-cost alternatives and local waste materials. Collaboration between academia and industry is encouraged to expedite technological advances and broaden applications. This article also underscores the need to develop economic and business models emphasizing the long-term benefits of these materials, including lower life-cycle costs and reduced environmental impact. Incentivizing adoption through financial mechanisms like tax credits and subsidies is suggested. The strategy also includes scaling up production technology, fostering industrial collaboration for commercial viability, and developing global supply chains. Educational programs for professionals and regulators are recommended to enhance awareness and adoption. Additionally, comprehensive life-cycle assessments are proposed to demonstrate environmental benefits. The strategy culminates in expanding the applications of these materials beyond construction, fostering international collaboration for knowledge sharing, and thus positioning these materials as essential for sustainable construction and climate change mitigation. Ključne besede: geopolymers, alkali activated materials, perspective Objavljeno v DiRROS: 15.04.2024; Ogledov: 517; Prenosov: 512 Celotno besedilo (1,63 MB) Gradivo ima več datotek! Več... |
2. Environmental and biological impact of fly ash and metakaolin-based alkali-activated foams obtained at 70°C and Fired at 1,000°CCristina Leonelli, Janez Turk, Giovanni Dal Poggetto, Michelina Catauro, Katja Traven, Alenka Mauko Pranjić, Vilma Ducman, 2022, izvirni znanstveni članek Povzetek: Alkali-activated foams (AAFs) are inorganic porous materials that can be obtained at temperatures well below 100° C with the use of inorganic wastes as aluminosilicate precursors. In this case, fly ash derived from a Slovenian power plant has been investigated. Despite the environmental benefits per se, due to saving of energy and virgin materials, when using waste materials, it is of extreme importance to also evaluate the potential leaching of heavy metal cations from the alkali-activated foams. This article presents an environmental study of a porous geopolymer derived from this particular fly ash, with respect to the leachability of potentially hazardous elements, its environmental toxicity as determined by biological testing, and the environmental impact of its production. In particular, attention was focused to investigate whether or not 1,000 °C-fired alkali- activated fly ash and metakaolin-based foams, cured at 70 °C, are environmentally friendlier options compared to unfired ones, and attempts to explain the rationale of the results were done. Eventually, the firing process at 1,000 ° C, apart from improving technical performance, could reinforce heavy metal cation entrapment within the aluminosilicate matrix. Since technical performance was also modified by addition of different types of activators (K-based or Na-based), as well as by partial replacement of fly ash with metakaolin, a life cycle assessment (LCA) analysis was performed to quantify the effect of these additions and processes (curing at 70 ° C and firing at 1,000 °C) in terms of global warming potential. Selected samples were also evaluated in terms of leaching of potentially deleterious elements as well as for the immobilization effect of firing. The leaching test indicated that none of the alkali-activated material is classified as hazardous, not even the as-received fly ash as component of new AAF. All of the alkali-activated foams do meet the requirements for an inertness. The highest impact on bacterial colonies was found in samples that did not undergo firing procedures, i.e., those that were cured at 70 °C, which induced the reduction of bacterial Enterococcus faecalis viability. The second family of bacteria tested, Escherichia coli, appeared more resistant to the alkaline environment (pH = 10–12) generated by the unfired AAMs. Cell viability recorded the lowest value for unfired alkali-activated materials produced from fly ash and K-based activators. Its reticulation is only partial, with the leachate solution appearing to be characterized with the most alkaline pH and with the highest ionic conductivity, i.e., highest number of soluble ions. By LCA, it has been shown that 1) changing K-based activators to Na-based activators increases environmental impact of the alkali-activated foams by 1%–4% in terms of most of the impact categories (taking into account the production stage). However, in terms of impact on abiotic depletion of elements and impact on ozone layer depletion, the increase is relatively more significant (11% and 18%, respectively); 2) replacing some parts of fly ash with metakaolin also results in relatively higher environmental footprint (increase of around 1%–4%, while the impact on abiotic depletion of elements increases by 14%); and finally, 3) firing at 1,000°C contributes significantly to the environmental footprint of alkali- activated foams. In such a case, the footprint increases by around one third, compared to the footprint of alkali-activated foams produced at 70 ° C. A combination of LCA and leaching/toxicity behavior analysis presents relevant combinations, which can provide information about long-term environmental impact of newly developed waste-based materials. Ključne besede: alkali activated materials, geopolimers, leaching, LCA Objavljeno v DiRROS: 20.06.2023; Ogledov: 676; Prenosov: 331 Celotno besedilo (3,42 MB) Gradivo ima več datotek! Več... |
3. Antibacterial properties and cytotoxicity of 100% waste derived alkali activated materials : slags and stone wool-based bindersCaterina Sgarlata, Giovanni Dal Poggetto, Federica Piccolo, Michelina Catauro, Katja Traven, Mark Češnovar, Hoang Nguyen, Juho Yliniemi, Luisa Barbieri, Vilma Ducman, Isabella Lancellotti, Cristina Leonelli, 2021, izvirni znanstveni članek Povzetek: In this study we compare the leaching behavior and the antibacterial and cytotoxic properties of 100% slag or stone wool derived alkali activated materials. The antibacterial activity was measured as the inhibiting capacity against two Gram- negative bacterial strains, Escherichia coli and Pseudomonas aeruginosa and one Gram-positive bacterial strain: Enterococcus faecalis. The cytotoxicity properties were tested on mouse embryonic fibroblast NIH-3T3 cell-line. It was proved that the high quality of the 3D aluminosilicate network of the consolidated materials obtained from powders of CaO or MgO-rich slags or stone wool, opportunely activated with NaO and/or Na-silicate, was capable of stabilizing heavy metal cations. The concentrations of leachate heavy cations were lower than the European law limit when tested in water. The effect of additives in the composites, basal fibers or nanocellulose, did not reduce the chemical stability and slightly influenced the compressive strength. Weight loss in water increased by 20% with basalt fibers addition, while it remained almost constant when nanocellulose was added. All the consolidated materials, cement-like in appearance, exhibited limited antibacterial properties (viability from 50 to 80% depending on the bacterial colony and the amount of sample) and absence of cytotoxicity, envisaging good acceptance from part of the final consumer and zero ecological impact. CaO-rich formulations can replace ordinary Portland cement (showing bacterial viability at 100%) with a certain capability for preventing the reproduction of the E. coli and S. aureus bacteria with health and environmental protection results. Ključne besede: antibacterial properties, cytotoxicity, alkali-activated materials, slag, stone wool, waste utilization, social acceptance Objavljeno v DiRROS: 22.05.2023; Ogledov: 689; Prenosov: 498 Celotno besedilo (2,31 MB) Gradivo ima več datotek! Več... |
4. Alkali activation of metallurgical slags : reactivity, chemical behavior, and environmental assessmentIsabella Lancellotti, Federica Piccolo, Katja Traven, Mark Češnovar, Vilma Ducman, Cristina Leonelli, 2021, izvirni znanstveni članek Povzetek: Alkali-activated materials (AAMs) represent a promising alternative to conventional building materials and ceramics. Being produced in large amounts as aluminosilicate-rich secondary products, such as slags, they can be utilized for the formulation of AAMs. Slags are partially crystalline metallurgical residues produced during the high temperature separation of metallic and non-metallic materials in the steelmaking processes. In the present study, the electric arc furnace carbon or stainless steel slag (EAF) and secondary metallurgical slag such as ladle furnace basic slag (LS) were used as precursors in an alkali-activation process. EAF slag, with its amorphous fraction of about 56%, presented higher contents of soluble Si and Al species with respect to ladle slag R (35%). However, both are suitable to produce AAM. The leaching behavior shows that all the release values are below the regulation limit. All the bivalent ions (Ba, Cd, Cu, Ni, Pb, and Zn) are well immobilized in a geopolymeric matrix, while amphoteric elements, such as As and Cr, show a slight increase of release with respect to the corresponding slag in alkaline and aqueous environments. In particular, for Sb and As of AAM, release still remains below the regulation limits, while Mo presents an increase of leaching values that slightly exceeds the limit for landfill non-dangerous waste. Ključne besede: slag, aluminosilicate materials, chemical reactivity, cold consolidation, alkali activation, leaching test, open access Objavljeno v DiRROS: 22.05.2023; Ogledov: 672; Prenosov: 369 Celotno besedilo (4,49 MB) Gradivo ima več datotek! Več... |