Digitalni repozitorij raziskovalnih organizacij Slovenije

Iskanje po repozitoriju
A+ | A- | Pomoč | SLO | ENG

Iskalni niz: išči po
išči po
išči po
išči po

Možnosti:
  Ponastavi


Iskalni niz: "avtor" (Andrea D'Amuri) .

1 - 10 / 111
Na začetekNa prejšnjo stran12345678910Na naslednjo stranNa konec
1.
Compartment fire dynamics in taller timber buildings : guidance for performance-based fire safety engineering
Ian Pope, Antonela Čolić, Chamith Karannagodage, Ahmed Ahmed Ali Awadallah, Andrea Lucherini, 2025, samostojni znanstveni sestavek ali poglavje v monografski publikaciji

Povzetek: In comparison to non-combustible construction materials commonly used for taller buildings, timber elements can significantly alter the fire dynamics in a compartment. This fundamentally challenges many of the conventional fire safety strategies and design approaches for mid-rise and high-rise buildings. Consequently, many building industry practitioners are questioning the limitations of existing methodologies, while searching for additional ways to account for this different fire behaviour in the design, construction, and operation of timber buildings. In seeking to address these questions, this chapter describes the state-of-the-art and recent advances in understanding the fire behaviour in compartments with areas of exposed timber (e.g., engineered wood products), and protected timber elements that may contribute to the fire if their encapsulation fails. Relevant experimental findings and engineering approaches to date are summarised and discussed, and design guidance is provided in relation to the typical phases of realistic or ‘natural’ fires, namely the growth phase, the fully-developed phase, the fire decay, and the cooling phase. Critical fire phenomena and their impacts on the fire safety strategy are addressed, such as fire spread; active fire suppression; heat induced delamination and char fall-off; and self-extinguishment.
Ključne besede: timber, fire dynamics, fire safety, self-extinguishment, heat induced delamination, char fall-off
Objavljeno v DiRROS: 18.11.2025; Ogledov: 5; Prenosov: 5
.pdf Celotno besedilo (974,53 KB)
Gradivo ima več datotek! Več...

2.
3.
Structural fire behaviour
Felix Wiesner, Daniel Brandon, Andrea Lucherini, Pedro Palma, 2025, samostojni znanstveni sestavek ali poglavje v monografski publikaciji

Povzetek: Fire safety and fire protection objectives require that buildings and parts of buildings do not collapse during a fire. This requires that the load-carrying capacity is maintained to a minimum acceptable level during a fire. This chapter briefly describes the historical background and state of the art of fire resistance and its determination for timber members through testing or calculations. The thermal and mechanical principles that underpin structural behaviour of wood at elevated temperatures are explained in the context of explicit calculation methods that enable explicit evaluation of the structural capacity beyond fire resistance, which is a formalised and codified assessment of structural elements against a standard fire. The importance of connections to the overall structure in fire is explained along with suitable design considerations. Ultimately, knowledge gaps with respect to novel and more complex engineered timber products for taller timber buildings are highlighted alongside potential limitations of established design parameters.
Ključne besede: fire resistance, fire safety, structures, load-carrying capacity, timber, connections
Objavljeno v DiRROS: 18.11.2025; Ogledov: 5; Prenosov: 5
.pdf Celotno besedilo (1,01 MB)
Gradivo ima več datotek! Več...

4.
Tuning the photocatalytic activity of nanocrystalline titania by phase composition control and nitrogen doping, using different sources of nitrogen
Nejc Rozman, Luka Škrlep, Miran Gaberšček, Andrijana Sever Škapin, 2014, izvirni znanstveni članek

Povzetek: Titania nanoparticles were synthesized by employing the hydrothermal method and using TiOSO4as a titanium source. By varying pH between 0.5 and 1.0 and adding isopropanol to the hydrothermal reaction mixture, different mixtures of anatase, rutile, and brookite were obtained. The samples were also doped with nitrogen at different N concentrations using, respectively, urea, ammonium nitrate, and tripropylamine as nitrogen sources. The samples were characterized by X-ray powder diffraction, field emission scanning electron microscopy, infrared spectroscopy, UV-Vis diffuse reflectance spectroscopy and according to their specific surface area. Additionally, their photocatalytic activity was measured in a gas-solid reactor system. The results show that low pH favours rutile formation, whereas a higher pH yields mixed phase titania polymorphs. Isopropanol addition also favours rutile formation, and boosted the photocatalytic activity of the resulted particles. Contrary to most data in the literature, rutile turned out to be the more active phase in the present investigation. Nitrogen doping, on the other hand, did not contribute to higher photocatalytic activity, but was rather detrimental to it.
Ključne besede: titanium dioxide, rutile, hydrothermal synthesis, photocatalysis, nitrogen doping
Objavljeno v DiRROS: 26.09.2025; Ogledov: 256; Prenosov: 100
.pdf Celotno besedilo (503,29 KB)
Gradivo ima več datotek! Več...

5.
Enhancing ex situ cultivation of Mediterranean Fucales: species-specific responses of Gongolaria barbata and Ericaria crinita seedlings to algal extracts
Ana Lokovšek, Martina Orlando-Bonaca, Edi Gljušćić, Andrea Bilajac, Ljiljana Iveša, Alberta Di Cave, Saverio Savio, Federico Ortenzi, Domen Trkov, Roberta Congestri, Annalisa Falace, 2025, izvirni znanstveni članek

Povzetek: Mediterranean brown algal forests, dominated by Cystoseira sensu lato species, are undergoing widespread decline due to the cumulative effects of anthropogenic pressure and climate-related stressors. Restoration efforts increasingly rely on ex situ cultivation and outplanting of seedlings, yet early developmental stages often suffer from low survival and growth rates. This study investigated the potential of algal extracts to enhance the seedling development and survival in two canopy-forming species, Gongolaria barbata and Ericaria crinita. We tested extracts from a cyanobacterium (Trichormus variabilis), two microalgae (Desmodesmus sp. and Cylindrotheca closterium), and a commercial macroalgal formulation (AlgatronCifo®) at varying concentrations under controlled mesocosm conditions. Seedling performance was significantly influenced by extract type, and target species identity. Notably, a low-concentration Desmodesmus sp. extract (0.07 mg mL− 1 ) improved survival and growth, whereas T. variabilis exerted an inhibitory effect on G. barbata. AlgatronCifo® did not outperform Desmodesmus sp. extract in promoting seedling development. These findings suggest that specific extracts from green microalgae could improve protocols for the early stages of restoration, offering a scalable tool for rehabilitating degraded marine forests. However, the results underscore the importance of species-specific optimization and the need for in situ validation of biostimulant-based restoration approaches.
Ključne besede: Cystoseira s.l., seaweed biostimulants, microalgal extracts, seedling development, restoration, Mediterranean sea
Objavljeno v DiRROS: 22.09.2025; Ogledov: 246; Prenosov: 107
.pdf Celotno besedilo (7,43 MB)
Gradivo ima več datotek! Več...

6.
Plasma treatment-promising tool for preparation of disposable monolithic columns
Ita Junkar, Gregor Primc, Tanja Lukan, Matic Resnik, Janez Kovač, Andrijana Sever Škapin, Aleš Podgornik, Miran Mozetič, 2015, izvirni znanstveni članek

Povzetek: Atmospheric pressure plasma jet was employed to improve adhesion between polypropylene (PP) column wall and monolith used in chromatography. Different treatment conditions for modification of PP tube were used and the effects of treatment were analysed with X-ray photoelectron spectroscopy (XPS) and atomic force microscopy (AFM). Modified surfaces had higher oxygen content and surface was covered with small grain like structures. To explore effects of modification on adhesion between PP tube and monolith tensile strength measurements were conducted. It was shown that appropriate treatment conditions significantly increased bonding strength. The improvement of adhesion was attributed to increased oxygen functional groups obtained from plasma.
Objavljeno v DiRROS: 05.09.2025; Ogledov: 224; Prenosov: 99
.pdf Celotno besedilo (1,00 MB)
Gradivo ima več datotek! Več...

7.
8.
Investigating the thermal penetration in structural timber elements exposed to natural fires
Andrea Lucherini, Vladimír Mózer, 2025, objavljeni znanstveni prispevek na konferenci

Povzetek: This study investigates fire-induced charring and thermal penetration in structural timber elements exposed to natural fire conditions, with a focus on the critical role of the cooling phase. A simplified 1D heat transfer model, based on Eurocode 5 temperature-dependent material properties, is implemented to simulate the thermal response of timber members subjected to Eurocode parametric fire curves. The analysis quantifies the char depth (300 °C isotherm) and the zero-strength layer, using both temperature-based (80-300 °C and 120-300 °C) and reduced mechanical properties approaches (tension and compression). Results show that, while the char depth predominantly develops during the heating phase, the zero-strength layer continues to grow during cooling, often reaching a thickness comparable to the char layer. The effective char depth (char depth + zero-strength layer) typically reaches its maximum towards the end of the cooling phase, representing the most critical condition for load-bearing capacity. The most severe conditions arise in low ventilation and high fuel load scenarios, characterised by long-duration fires rather than the highest temperatures. The findings highlight the need to explicitly consider the cooling phase in performance-based fire design for timber structures.
Ključne besede: timber structures, fire safety, charring, zero-strength layer, cooling
Objavljeno v DiRROS: 16.07.2025; Ogledov: 327; Prenosov: 232
.pdf Celotno besedilo (3,57 MB)
Gradivo ima več datotek! Več...

9.
10.
The genetic consequences of population marginality : a case study in maritime pine
Adélaïde Theraroz, Santiago C. González-Martínez, Carlos Guadaño-Peyrot, Juliette Archambeau, Sara Pinosio, Francesca Bagnoli, Andrea Piotti, Camilla Avanzi, Giovanni G. Vendramin, Ricardo Alía, Delphine Grivet, Marjana Westergren, 2024, zaključena znanstvena zbirka raziskovalnih podatkov

Povzetek: This dataset was produced by a consortium of European research Intitutes. For the data collection, needles were sampled from a total of 1,510 individuals from 82 maritime pine populations covering all previously identified gene pools throughout the species range. 10,185 SNPs were genotyped from the multispecies 4TREE SNPs chip (chip produced within the framework of the B4est project). This dataset was used to carry out a population genetics study.
Ključne besede: population genetics, conservation genetics, marginal populations, Pinus pinaster, genetic indicators
Objavljeno v DiRROS: 08.07.2025; Ogledov: 309; Prenosov: 232
.txt Celotno besedilo (2,29 KB)
Gradivo ima več datotek! Več...

Iskanje izvedeno v 0.2 sek.
Na vrh