Digital repository of Slovenian research organisations

Search the repository
A+ | A- | Help | SLO | ENG

Query: search in
search in
search in
search in

Options:
  Reset


Query: "keywords" (raman spectroscopy) .

1 - 5 / 5
First pagePrevious page1Next pageLast page
1.
Raman microspectroscopy of garnets from Sfibulae from the archaeological site Lajh (Slovenia)
Saša Kos, Matej Dolenec, Judita Lux, Sabina Dolenec, 2020, original scientific article

Abstract: Garnets (19 pieces) of Late Antique S-fibulae from the archaeological site at Lajh-Kranj (Slovenia) were analysed with Raman microspectroscopy to obtain their mineral characteristic, including inclusion assemblage. Most garnets were determined as almandines Type I of pyralspite solid solution series; however, three garnets showed a higher Mg, Mn and Ca contents and were determined as almandines Type II. Most significant Raman bands were determined in the range of 169–173 cm−1 (T(X2+)), 346–352 cm−1 (R(SiO4)), 557–559 cm−1 (ν2), 633–637 cm−1 (ν4), 917–919 cm−1 (ν1), and 1042–1045 cm−1 (ν3). Shifting of certain Raman bands toward higher frequencies was the result of an increase of the Mg content in the garnet composition, which also indicates the presence of pyrope end member in solid garnet solutions. Inclusions of apatite, quartz, mica, magnetite, ilmenite, as well as inclusions with pleochroic or radiation halo and tension fissures (zircon), were found in most of the garnets. Rutile and sillimanite were found only in garnets with the highest pyrope content. Spherical inclusions were also observed in two garnets, which may indicate the presence of melt or gas residues. The determined inclusion assemblage indicates the formation of garnets during medium- to high-grade metamorphism of amphibolite or granulite facies. According to earlier investigations of the garnets from Late Antique jewellery, the investigated garnets are believed to originate from India.
Keywords: garnets, inclusions, Sfibulae, Late Antiquity, provenance, Raman microspectroscopy, XRF spectroscopy
Published in DiRROS: 20.12.2023; Views: 143; Downloads: 112
.pdf Full text (35,45 MB)
This document has many files! More...

2.
Corrosion behavior of steel in pore solutions extracted from different blended cements
Miha Hren, Tadeja Kosec, Andraž Legat, 2020, original scientific article

Abstract: Mortar specimens made from four different types of cement, CEM I, CEM II, CEM III, and CEM IV, were prepared and pore solutions extracted. Three different types of exposure were studied: noncarbonated without chlorides, noncarbonated with chlorides, and carbonated with chlorides. Various electrochemical methods (linear polarization, potentiodynamic polarization measurements) were implemented to characterize the processes of corrosion on steel in these solutions. The type and extent of corrosion products were evaluated by means of various spectroscopic techniques. Specific differences in the type and extent of corrosion damage were determined and compared for each of the extracted pore solutions from the different blended cements. An attempt was made to classify these differences in comparison with the reference cement (CEM I) and in relation to the different types of exposure.
Keywords: corrosion, steel in pore water, blended cements, Raman Spectroscopy
Published in DiRROS: 22.08.2023; Views: 252; Downloads: 118
.pdf Full text (1,25 MB)
This document has many files! More...

3.
Corrosion and protection of non-patinated, sulphide- and chloride-patinated bronze
Živa Novak, Tadeja Kosec, 2022, original scientific article

Abstract: The surface of bronze undergoes changes when it is exposed to a polluted atmosphere, and bronze should therefore be protected from this natural deterioration. The most common protective coating currently in use is Incralac, which includes toxic components and is reported to dissolve a few months after application. This work therefore investigates a fluoropolymer-based coating (FA-MS), and compares it to the protection offered by Incralac. Bronze samples (non-patinated, sulphide-patinated or chloride-patinated) were exposed to simulated urban rain for four months. The corrosion products formed were characterised using SEM/EDS and Raman analyses. To study the protection efficiency of the newly developed fluoropolymer coating (FA-MS) and Incralac protection, various electrochemical methods were used: measurements of open circuit potential linear polarisation and potentiodynamic measurements. Findings show that the FA-MS coating provides a protection efficiency of 71 % for chloride-patinated bronze and 99.5 % for sulphide-patinated bronze. Contact angles of the FA-MS samples were higher than those of the unprotected samples or the samples protected by Incralac, indicating better hydrophobic properties of the FA-MS coating.
Keywords: bronze, corrosion, SEM/EDS analyses, Raman spectroscopy, electrochemistry, odprti dostop
Published in DiRROS: 31.05.2023; Views: 299; Downloads: 111
.pdf Full text (1,30 MB)
This document has many files! More...

4.
An electrochemical and spectroscopic study of surfaces on bronze sculptures exposed to urban environment
Dajana Mikić, Helena Otmačić Ćurković, Tadeja Kosec, Neven Peko, 2021, original scientific article

Abstract: Polluted urban environment enhances dissolution of patina and underlying bronze material of recent and historical bronze sculptures exposed outdoors. In this work, two bronze statues, situated in one of the most polluted Croatian cities, were examined in order to characterize composition of patina and its electrochemical stability. The composition of patina on several positions on each sculpture was determined by EDS, Raman spectroscopy, and FTIR measurements. Electrochemical impedance spectroscopy measurements were conducted in order to evaluate the corrosion stability of both patina and underlying bronze. Results obtained in this work show that the two examined bronze sculptures were covered with patina layer that was mainly composed of copper sulfides and sulphates, which is in accordance with the high concentrations of H2S and SO2 in the atmosphere. However, the variations in the appearance of FTIR and Raman spectra revealed that the amount of each species differed from spot to spot, as well as the fact that other compounds, such as carbonates, were present at some areas. This difference in patina composition was reflected in electrochemical behavior as observed by electrochemical impedance spectroscopy.
Keywords: bronze, corrosion, spectroscopy, FTIR, Raman, EIS, open access
Published in DiRROS: 16.05.2023; Views: 274; Downloads: 159
.pdf Full text (4,82 MB)
This document has many files! More...

5.
Comparative study of interactions of aliskiren and AT [sub] 1 receptor antagonists with lipid bilayers
A. Sadegphour, Michael Rappolt, Dimitrios Ntountaniotis, Petros Chatzigeorgioug, Kyriakos Viras, Grigorios Megariotis, M. Papadopoulos, Eleni Siapi, Gregor Mali, Thomas Michael Mavromoustakos, 2015, original scientific article

Abstract: The renin-angiotensin-aldosterone system (RAAS) plays a key role in the regulation of blood pressure. Renin is the rate limiting enzyme of the RAAS and aliskiren is a highly potent and selective inhibitor of the human renin. Renin is known to be active both in the circulating blood stream as well as locally, when bound to the (pro)-renin receptor ((P)RR). In this study we have investigated a possible mechanism of action of aliskiren, in which its accumulation in the plasma membrane is considered as an essential step for effective inhibition. Aliskiren's interactions with model membranes (cholesterol rich and poor) have been investigated by applying different complementary techniques: differential scanning calorimetry (DSC), Raman spectroscopy, magic angle spinning (MAS) nuclear magnetic resonance (NMR) spectroscopy and small- and wide-angle X-ray scattering (SAXS and WAXS). In addition, in silico molecular dynamics (MD) calculations were applied for further confirmation of the experimental data. Aliskiren's thermal effects on the pre- and main transition of dipalmitoyl-phosphatidylcholine (DPPC) membranes as well as its topographical position in the bilayer show striking similarities to those of angiotens.in II type 1 receptor (AT1R) antagonists. Moreover, at higher cholesterol concentrations aliskiren gets expelled from the membrane just as it has been recently demonstrated for the angiotensin receptor blocker (ARB) losartan. Thus, we propose that both the AT1R and the (P)RR-bound renin active sites can be efficiently blocked by membrane-bound ARBs and aliskiren when cholesterol rich membrane rafts/caveolae are formed in the vicinity of the receptors.
Keywords: aliskiren, renin, PRR, DPPC bilayers, raman spectroscopy, solid state NMR spectroscopy, SAXS and WAXS, MD simulations
Published in DiRROS: 26.01.2015; Views: 4294; Downloads: 295
URL Link to file

Search done in 0.18 sec.
Back to top