1. Dynamic mechanical analysis of fpu bonded beech wood at various temperaturesMartin Capuder, Boris Azinović, Andreja Pondelak, Paweł Rutkowski, Magdalena Szumera, Matthew Schwarzkopf, Arkadiusz Kwiecień, Klaudia Śliwa-Wieczorek, Jaka Gašper Pečnik, 2025, published scientific conference contribution Abstract: This study investigates the dynamic mechanical properties of flexible polyurethane (FPU) adhesives bonded to European beech wood (Fagus sylvatica L.) using Dynamic Mechanical Analysis (DMA) over a range of temperatures and frequencies. Samples included clear beech wood and three-layered composite (beech:FPU:beech). DMA tests were performed using a three-point bending setup at 1 Hz and 10 Hz in the temperature range from -120°C to 140°C. The results demonstrated high thermal stability and strong bonding performance of FPU adhesives on beech wood. Frequency-dependent responses varied among FPU types but resembled the behavior of solid wood at lower temperatures. This confirms the suitability of DMA for evaluating adhesive-wood composite behavior under dynamic conditions. The combination of FPU adhesives and beech wood showed potential for thermally stable and energy-dissipating bonded assemblies.
Keywords: dynamic mechanical analysis, FPU, beech wood
Published in DiRROS: 27.08.2025; Views: 460; Downloads: 218
 Full text (2,05 MB)
This document has many files! More... |
2. Efficiency of FRPU strengthening of a damaged masonry infill wall under in-plane cyclic shear loading and elevated temperaturesPetra Triller, Konrad Kwiecień, Arkadiusz Kwiecień, Uroš Bohinc, BogusŁaw Zając, Marcin Tekieli, Magdalena Szumera, Theodoros Rousakis, Vachan Vanian, Ahmet Tugrul Akyildiz, Alberto Viskovic, 2024, original scientific article Abstract: This paper presents results of in-plane shear tests carried out at the ZAG laboratory in Ljubljana (Slovenia) on a RC frame with masonry infill made of clay blocks (KEBE OrthoBlock). The frame was loaded with constant vertical loads at the top of the columns and then by gradually increasing horizontal cyclic loads at the top beam level. Acquired forces and measured displacements allowed capturing hysteretic behavior for determination of dissipation energy. In addition, two Digital Image Correlation (DIC) systems, Aramis and the CivEng Vision, were used to visualize the behavior of the tested specimens, with an emphasis on computing locally required information about the behavior of highly deformable interfaces. Three types of specimens were tested in-plane: the reference specimen in form of plain RC frame, the reference specimen with constructed masonry infill without any strengthening and the specimen, previously damaged and then strengthened on both sides using glass mesh bonded to the infill and the RC frame using flexible adhesive made of polyurethane matrix (Glass Fiber Reinforced PolyUrethane - GFRPU system). The strengthening process, allowed the specimen to withstand additional cyclic loads, reaching a maximum drift of 3.6 % without serious damage disqualifying the structure from further exploitation. The GFRPU strengthening system was found to be highly effective in preventing infill collapse of damaged masonry infill wall during in-plane loading. Additionally, the results of extended thermal analysis of PU are presented as polymers are, in general, a material, poorly resistant to heat. However, the analyzed PU manifested stable properties up to 200 degrees Celsius, which makes this material promising in civil engineering applications at elevated temperatures.
Keywords: masonry blocks, damaged infill, fiber Reinforced PolyUrethane, external composite strengthening, in-plane shear, thermal tests, DIC measurements
Published in DiRROS: 14.08.2024; Views: 1063; Downloads: 681
Full text (21,68 MB)
This document has many files! More... |
