Digitalni repozitorij raziskovalnih organizacij Slovenije

Iskanje po repozitoriju
A+ | A- | Pomoč | SLO | ENG

Iskalni niz: išči po
išči po
išči po
išči po

Možnosti:
  Ponastavi


Iskalni niz: "ključne besede" (skidding) .

1 - 2 / 2
Na začetekNa prejšnjo stran1Na naslednjo stranNa konec
1.
Assessing maximum loads when skidding wood uphill with tractors
Boštjan Košir, Jurij Marenče, 2008, izvirni znanstveni članek

Povzetek: The results of measuring maximum loads on different slopes when skidding uphill with WOO DY 110 cable skidder and adapted 4WD agricultural tractor AGT 835 are described in the article. Both tractors are very different and were chosen for the purpose of finding the limits of uphill skidding. Besides the slope, the pre-designated loads of different sizes and log orientation (butt-end or top-end forward) have been main variables. The trial was conducted on two concave shaped test skid trails in the forest. On the lower altitudes, the skid trails had small inclination, which slowly increased to 42% on the track where WOODY 110 was tested, and 27% where AGT 835 was measured. First the loads were skidded uphill with butt-end and then with top-end forward. The purpose was to choose too heavy loads, as we wished to stop tractors due to overload, but on different slopes. The proper load formation (butt-end forward if possible) in uphill skidding is most important on steeper skid trails. The dependency between maximum load and slope is linear. The calculated theoretical maximum load on horizontal surface enables us to make similar assessment for any other tractor weighing between 2 and 7 tons. For this purpose, John Deere 6220 and LIMB 80 LUXS adapted agricultural tractors for forest use were chosen and compared. The ratio between the tractor load on different slopes and tractor weight was calculated for all four tractors included in our comparison. Apart from the weight, tractor's engine torque (power) has the decisive influence on the load size. Maximum loads on different slope categories were calculated according to different engine powers.
Ključne besede: tractor, skidding wood, maximum slope, maximum load
Objavljeno v DiRROS: 12.07.2017; Ogledov: 4239; Prenosov: 1789
.pdf Celotno besedilo (1,19 MB)

2.
Wheelslip in skidding with the AGT 835 T adapted farm tractor
Jurij Marenče, Boštjan Košir, 2007, izvirni znanstveni članek

Povzetek: The paper presents a wheelslip measurement method for small farm tractors (AGT835 T) adapted for skidding, with mechanical and hydrostatic mechanical transmissions. The research focused on uphill skidding, as slip values measured in uphill skidding are higher than in downhill skidding. A comparisonwas made of the performance of tractors carrying equal load but equipped with mechanical and hydrostatic transmission systems. The hydrostaticdrive causes higher negative load values in downhill skidding, and slightly higher slippage. As for hydrostatic tractors, wheelslip is higher in uphill skidding than in downhill skidding. The increase in the sloping of the terrain causes wheelslip to rise progressively. When a tractor travels uphill,slip is linked to a loss of energy. Wheelslip measurements are therefore important for determining the optimum conditions for individual tractor types.
Ključne besede: skidding, farm tractor, wheelslip, measurement
Objavljeno v DiRROS: 12.07.2017; Ogledov: 4299; Prenosov: 1907
.pdf Celotno besedilo (722,66 KB)

Iskanje izvedeno v 0.08 sek.
Na vrh