71. |
72. |
73. |
74. Exploration of macromolecular phenotype of human skeletal muscle in diabetes using infrared spectroscopyBarbara Zupančič, Chiedozie Kenneth Ugwoke, Mohamed Elwy Abdelmonaem, Armin Alibegović, Erika Cvetko, Jože Grdadolnik, Anja Šerbec, Nejc Umek, 2023, izvirni znanstveni članek Povzetek: Introduction: The global burden of diabetes mellitus is escalating, and more efficient investigative strategies are needed for a deeper understanding of underlying pathophysiological mechanisms. The crucial role of skeletal muscle in carbohydrate and lipid metabolism makes it one of the most susceptible tissues to diabetes-related metabolic disorders. In tissue studies, conventional histochemical methods have several technical limitations and have been shown to inadequately characterise the biomolecular phenotype of skeletal muscle to provide a holistic view of the pathologically altered proportions of macromolecular constituents. Materials and methods: In this pilot study, we examined the composition of five different human skeletal muscles from male donors diagnosed with type 2 diabetes and non-diabetic controls. We analysed the lipid, glycogen, and collagen content in the muscles in a traditional manner with histochemical assays using different staining techniques. This served as a reference for comparison with the unconventional analysis of tissue composition using Fourier-transform infrared spectroscopy as an alternative methodological approach. Results: A thorough chemometric post-processing of the infrared spectra using a multi-stage spectral decomposition allowed the simultaneous identification of various compositional details from a vibrational spectrum measured in a single experiment. We obtained multifaceted information about the proportions of the different macromolecular constituents of skeletal muscle, which even allowed us to distinguish protein constituents with different structural properties. The most important methodological steps for a comprehensive insight into muscle composition have thus been set and parameters identified that can be used for the comparison between healthy and diabetic muscles. Conclusion: We have established a methodological framework based on vibrational spectroscopy for the detailed macromolecular analysis of human skeletal muscle that can effectively complement or may even serve as an alternative to histochemical assays. As this is a pilot study with relatively small sample sets, we remain cautious at this stage in drawing definitive conclusions about diabetes-related changes in skeletal muscle composition. However, the main focus and contribution of our work has been to provide an alternative, simple and efficient approach for this purpose. We are confident that we have achieved this goal and have brought our methodology to a level from which it can be successfully transferred to a large-scale study that allows the effects of diabetes on skeletal muscle composition and the interrelationships between the macromolecular tissue alterations due to diabetes to be investigated.
Ključne besede: diabetes mellitus, skeletal muscle, metabolism, macromulecular composition, infrared spectroscopy, multivariate analysis, histochemical assays
Objavljeno v DiRROS: 11.01.2024; Ogledov: 231; Prenosov: 84
 Celotno besedilo (1,71 MB)
Gradivo ima več datotek! Več... |
75. |
76. |
77. Heavy minerals as indicators of source material in soils on carbonatesBarbara Čeplak, Miloš Miler, Nina Zupančič, Simona Jarc, 2023, izvirni znanstveni članek Povzetek: The origin of the soils formed on carbonate rocks remains uncertain, as they are probably of polygenetic origin. Of particular interest are the elevated contents of some trace elements detected in these soils, as they can hardly be attributed to insoluble residues of carbonate rock. The aim of this study was to uncover the relationship between heavy minerals in bedrock and soil and to identify other sources that influence the mineral and chemical composition of soil. We investigated representative samples of soils and dolomite bedrock as well as sandstones and marlstones from the nearby flysch basin as an expected source of the aeolian contribution. XRD and SEM/EDS showed that mineral diversity is higher in soils compared to the dolomites. Heavy minerals found in dolomite insoluble residue include sphalerite, Ti-oxide (probably rutile), zircon, fluorite, pyrite, minerals of REE phosphates and apatite group, interpreted as terrigenous detrital material. The mineral composition of soil heavy fraction is only partly following insoluble residues of bedrock and indicates possible aeolian contribution. Comparison with nearby flysch sandstones and marlstones showed similarities in mineralogical diversity by the presence of chromite and Fe-Cr(Mn) oxides (probably carmichaelite). Other minerals present in soils and flysch layers, such as Ti-oxide (probably rutile), zircon, REE phosphates, and pyrite grains, however, show similarities in mode of occurrence and transport indications. Signs of aeolian transport on the grains detected in soils were further confirmed by SEM/EDS.
Ključne besede: Phaeozem, Upper Triassic dolomite, flysch layers, trace elements, SEM/EDS
Objavljeno v DiRROS: 04.01.2024; Ogledov: 212; Prenosov: 49
Celotno besedilo (8,60 MB) |
78. Fibre reinforced alkali-activated rock woolMajda Pavlin, Barbara Horvat, Vilma Ducman, 2022, objavljeni znanstveni prispevek na konferenci Povzetek: Mineral wool, i.e. rock and glass wool, represents considerable challenge after its functional-time runs out due to its small density leading to large volume consumption during transport and in landfills where it usually ends. Because rock wool is mineralogically and chemically a promising precursor material for alkali-activation, it was milled from few centimetres-decimeters long fibres to micron-sized fibres. Since fibres in alkali-activated materials generally show an increase in mechanical strength, especially the bending strength, 1 m% of additional fibres (basalt, cellulose (2 types), glass, polypropylene, polyvinyl alcohol and steel fibres) was used in the alkali mixture, that was curred at 40 °C for 3 days. Time dependence of the mechanical strengths of alkali- activated materials with and without additional fibres was followed. Maximal increase of compressive and bending strength after 28 days was reached with polypropylene fibres, i.e. it was 20% and 30% higher than compressive and bending strength of alkali- activated material without additional fibres respectively.
Ključne besede: secondary raw material, alkali activated material, foaming, homogenization, mechanical strength
Objavljeno v DiRROS: 21.12.2023; Ogledov: 214; Prenosov: 71
Celotno besedilo (8,39 MB)
Gradivo ima več datotek! Več... |
79. Influence of homogenization of alkali-activated slurry on mechanical strengthBarbara Horvat, Mark Češnovar, Katja Traven, Majda Pavlin, Katja Koenig, Vilma Ducman, 2022, objavljeni znanstveni prispevek na konferenci Povzetek: Alkali-activated materials are promising materials for the construction industry due to the accessibility of the precursors, which are mainly secondary industrial by-products, and their cost- effective and energy-efficient production. Although these materials are not new, some of the parameters in the technological process are not yet fully understood and tested. Therefore, in this paper in the means of mechanical strength, the preparation of alkali-activated pastes by using a three-roll mill homogenization method is discussed. The influence of homogenization of alkali- activated slurry has been evaluated on different waste materials (fly ash, fly ash with metakaolin, slag mixture (electric arc furnace slag and ladle slag), glass wool, waste green ceramics), which are treated with different alkali activators (NaOH, commercial sodium silicate solution, laboratory-produced alkali activators based on waste cathode- ray tube glass) with different curing regimes (60 °C and 70 °C) and different drying methods (drying at room temperature, drying at 105 °C). The viscosity of the slurry before homogenization was higher than after homogenization, the distribution of elements was more uniform and the compressive strength higher in all homogenized alkali activated materials, regardless of other parameters.
Ključne besede: secondary raw material, alkali activated material, foaming, homogenization, mechanical strength
Objavljeno v DiRROS: 21.12.2023; Ogledov: 232; Prenosov: 76
Celotno besedilo (15,82 MB)
Gradivo ima več datotek! Več... |
80. |
