Digital repository of Slovenian research organisations

Search the repository
A+ | A- | Help | SLO | ENG

Query: search in
search in
search in
search in

Options:
  Reset


Query: "keywords" (monitoring) .

11 - 20 / 101
First pagePrevious page12345678910Next pageLast page
11.
Impact assessment of the Gajke and Brstje landfills on groundwater status using stable and radioactive isotopes
Sonja Cerar, Luka Serianz, Polona Vreča, Marko Štrok, Tjaša Kanduč, 2023, original scientific article

Abstract: Waste disposal in landfills represents a severe threat to aquatic environments on the local, regional, and global levels. In Slovenia, there are 69 registered landfills where groundwater is regularly monitored. However, isotope techniques are not regularly employed. Therefore, we employed isotope analysis of hydrogen, carbon, and oxygen in combination with total alkalinity to assess the impact of the selected landfill on groundwater and to evaluate the biogeochemical processes at work. The δ18O, δ2H, δ13CDIC, 3H activity and total alkalinity were determined in October 2020 at 12 sampling points from the surrounding area of the Gajke and Brstje landfills and leachate from the Gajke landfill. The δ18O (-9.24 ± 0.3 ‰) and δ2H (-64.9 ± 2.7 ‰) in groundwater indicate that the main water source consists in direct infiltration of precipitation, with no significant isotopic fractionation. Total alkalinity in the investigated area ranges from 5.45 to 73 mM and δ13CDIC from –14.9 to +6.1 ‰, respectively. Higher values of total alkalinity (up to 73 mM), δ13CDIC (up to +6.1 ‰), δ18O (-7.64 ‰) and 3H (209.8 TU) are detected in the leachate, indicating biogeochemical process related to CO2 reduction or methanogenesis. Methanogenesis could be present at locations GAP-10/13 (Brstje landfill) and G-2 (Gajke landfill) with δ13CDIC values ranging from –8.2 to –7.6 ‰ and with dissolved oxygen values around 0 % and elevated 3H values (from 16 to 18 TU). This study demonstrates the effectiveness of isotopic analysis as a valuable tool for monitoring landfills, revealing shifts in biogeochemical processes within the groundwater there.
Keywords: groundwater, monitoring, landfill, stable isotopes, tritium, Gajke, Brstje
Published in DiRROS: 16.01.2024; Views: 168; Downloads: 60
.pdf Full text (8,52 MB)

12.
Razširjenost dvojnozobega smrekovega lubadarja (Ips duplicatus) v Sloveniji v letu 2023
Maarten De Groot, Tine Hauptman, Marija Kolšek, 2023, short scientific article

Abstract: Članek prikazuje rezultate raziskave razširjenosti vrste Ips duplicatus (Sahlberg, 1836) v Sloveniji v letu 2023. Uporabili smo 14 režastih pasti tipa Theysohn, ki so bile opremljene s feromonom Dupliwit. V raziskavo smo vključili tudi tri križne prestrezne pasti brez feromona, ki so bile postavljene v sklopu drugega projekta in smo v njih odkrili vrsto I. duplicatus. Prisotnost vrste smo potrdili na šestih lokacijah, skupno pa smo ujeli osem osebkov. Predstavljena je razprava o pomenu teh najdb v kontekstu razširjenosti, spremljanja in upravljanja dvojnozobega smrekovega lubadarja.
Keywords: gozdovi, varstvo gozdov, monitoring, navadna smreka, Picea abies, podlubniki, invazivna tujerodna vrsta
Published in DiRROS: 10.01.2024; Views: 177; Downloads: 76
.pdf Full text (575,46 KB)
This document has many files! More...

13.
Elucidating nucleation stages of transgranular stress corrosion cracking in austenitic stainless steel by in situ electrochemical and optical methods
Sarmiento Klapper Helmuth, Bojan Zajec, Andreas Heyn, Andraž Legat, 2019, original scientific article

Abstract: The pitting and environmentally assisted cracking resistance of austenitic stainless steels (SS) is challenged in several industrial applications particularly those involving hot chloride-concentrated streams. Directional drilling used in the oil and gas exploration is one of these applications. Indeed, high strength CrMn-SS commonly used in drilling technology have a high tendency to fail by stress corrosion cracking (SCC) preceded by localized corrosion once subjected to highly chloride-concentrated drilling fluids at elevated temperatures. A comprehensive understanding regarding the mechanisms governing the transition from pitting into SCCis not currently available, though. Therefore, mechanistic aspects such as the effect of loading conditions on pit nucleation and repassivation as well as the synergistic effect between pit stabilization and the nucleation of a stress corrosion crack are of great practical significance. To investigate this an electrochemical-, optical- and mechanical- monitored SCC test was conducted on a CrMn-SS in an alkaline brine at elevated temperature. The transition from metastable to stable pitting and subsequently to SCC in this system was documented in-situ for the first time. Results supported H.S. Isaacs postulates regarding the interpretation of electrochemical signals and demonstrated that loading conditions affect pit nucleation and repassivation leading to a higher susceptibility of the material to pitting, which preceded SCC.
Keywords: pitting corrosion, stress corrosion cracking, monitoring, elektrochemical noise, austenitic stainless steel
Published in DiRROS: 23.11.2023; Views: 193; Downloads: 162
.pdf Full text (2,28 MB)
This document has many files! More...

14.
15.
Using statistical analysis of an acceleration-based bridge weigh-in-motion system for damage detection
Eugene J. O'Brien, Muhammad Arslan Khan, Daniel Patrick McCrum, Aleš Žnidarič, 2020, original scientific article

Abstract: This paper develops a novel method of bridge damage detection using statistical analysis of data from an acceleration-based bridge weigh-in-motion (BWIM) system. Bridge dynamic analysis using a vehicle-bridge interaction model is carried out to obtain bridge accelerations, and the BWIM concept is applied to infer the vehicle axle weights. A large volume of traffic data tends to remain consistent (e.g., most frequent gross vehicle weight (GVW) of 3-axle trucks); therefore, the statistical properties of inferred vehicle weights are used to develop a bridge damage detection technique. Global change of bridge stiffness due to a change in the elastic modulus of concrete is used as a proxy of bridge damage. This approach has the advantage of overcoming the variability in acceleration signals due to the wide variety of source excitations/vehicles–data from a large number of different vehicles can be easily combined in the form of inferred vehicle weight. One year of experimental data from a short-span reinforced concrete bridge in Slovenia is used to assess the effectiveness of the new approach. Although the acceleration-based BWIM system is inaccurate for finding vehicle axle-weights, it is found to be effective in detecting damage using statistical analysis. It is shown through simulation as well as by experimental analysis that a significant change in the statistical properties of the inferred BWIM data results from changes in the bridge condition.
Keywords: bridge health monitoring, bridge WIM, structural dynamics, damage detection, vehicle-bridge interaction
Published in DiRROS: 12.09.2023; Views: 265; Downloads: 135
.pdf Full text (8,01 MB)
This document has many files! More...

16.
Using bridge weigh-in-motion systems to monitor single-span bridge influence lines
Aleš Žnidarič, Jan Kalin, 2020, original scientific article

Abstract: Bridge weigh-in-motion systems use instrumented bridges or culverts to weigh vehicles as they pass over the structures. They also provide data to allow the calculation of several bridge performance indicators. The article starts with the basics of a bridge weigh-in-motion system and briefly describes two key bridge performance indicators, girder distribution factor and dynamic amplification factor, which are also derived from B-WIM measurements. The central part of the article focuses on monitoring of influence lines, the third key parameter that characterises the bridge performance under traffic loads. First, the method of calculating the bending moment influence lines from random heavy traffic is described. A coefficient of rotational stiffness is introduced, which defines the shape of influence lines around the supports as a linear combination of the ideal simply supported and fixed supported influence lines, to allow quantifying the influence line changes. Then the long-term monitoring of influence lines is investigated on four different single-span test bridges. The initial focus is given on the examination of the effect of temperature on the shape of influence lines. Finally, two sets of influence lines are compared on one test bridge, one from before and the other from after replacing the expansion joints and bearings. The work done so far confirms that calculating of influence lines from random vehicles with a B-WIM system is entirely feasible and that differences in their shape can be detected on single-span bridges. What remains to be investigated is the comparison of these differences to the actual damages and under which circumstances the proposed procedure can compete with or better the routine bridge inspection and the conventional monitoring techniques.
Keywords: bridge loading, bridge response, temperature dependency, influence line, monitoring
Published in DiRROS: 12.09.2023; Views: 331; Downloads: 126
.pdf Full text (2,38 MB)
This document has many files! More...

17.
Izgradnja lizimetrov za preučevanje izpiranja potencionalno nevarnih snovi iz gradbenih proizvodov
Janez Turk, Janko Urbanc, Ana Mladenovič, Alenka Sešek Pavlin, Primož Oprčkal, Karmen Fifer Bizjak, Barbara Likar, Marko Brodnik, Nina Mali, 2020, original scientific article

Abstract: Z uporabo recikliranih odpadkov v gradbeništvu nadomeščamo naravne materiale in s tem vzpostavljamo krožno gospodarstvo na lokalnem nivoju. Pomemben vidik je tudi ohranjanje naravnih virov. To je še posebno pereče pri zemeljskih delih (npr. zasipih in nasipih), kjer prihaja do velike porabe materialov. Geotehnični kompoziti iz recikliranih materialov, v primerjavi z naravnimi agregati ali zemljinami, lahko vsebujejo višje celotne koncentracije potencialno nevarnih snovi (težke kovine, klorid, sulfat, fluorid, organska onesnaževala itd.). Pogoj za uporabo takšnih kompozitov je, da so v njih potencialno nevarne snovi imobilizirane in da so zato iz kemijskega vidika trajno inertni. Možni vplivi na okolje, predvsem prenos različnih potencialno nevarnih snovi iz kompozitov v tla oziroma vodonosnik, so običajno ovrednoteni na laboratorijski ravni, medtem ko je njihovo obnašanje v dejanskem okolju slabo proučeno. Zato se pojavljajo zahteve po razvoju občutljivih, zanesljivih in cenovno ter časovno učinkovitih orodij za določitev masnih tokov potencialno nevarnih snovi iz gradbenih proizvodov, na primer geotehničnih kompozitov, pod vplivi različnih okoljskih dejavnikov. V članku predstavljamo postopek vzpostavitve terenskega laboratorija na osnovi sistema "pan" lizimetrov, za zbiranje izcednih voda iz zasipov, ki so bili izdelani iz geotehničnih kompozitov iz recikliranih materialov. Lizimetre smo konstruirali in izvedli tako, da je njihova izgradnja cenovno ugodna, hkrati pa so po svojih dimenzijah dovolj veliki, da reprezentativno odražajo procese v zgrajenih geotehničnih zasipih. Pridobljeni podatki o količini in parametrih izcedne vode bodo služili kot osnova za določanje vodne bilance in za študij imobilizacije potencialno nevarnih snovi v kompozitih. Hkrati bodo uporabljeni kot vhodni podatki za geokemijski numerični model, s katerim bomo simulirali transport potencialno nevarnih snovi, sproščenih iz preučevanih kompozitov, v različnih tipih vodonosnikov (npr. medzrnski in razpoklinski).
Keywords: lizimeter, izlužek, okoljski monitoring, geotehnični zasip, odpadki
Published in DiRROS: 12.09.2023; Views: 265; Downloads: 122
.pdf Full text (2,46 MB)
This document has many files! More...

18.
First record of the northern spruce bark beetle, Ips duplicatus (Sahlberg, 1836), in Slovenia
Andreja Kavčič, Zina Devetak, Barbara Piškur, Eva Groznik, Maarten De Groot, 2023, original scientific article

Abstract: The northern spruce bark beetle, Ips duplicatus (Sahlberg), has invaded Central Europe in the past century and continues to spread southwards and westwards. It has caused damage in some parts of Europe in recent decades and poses a serious threat to spruce forests across the continent. From 2018 to 2021, we conducted intensive monitoring to determine the status of I. duplicatus in Slovenia. We used different types of traps and pheromone lures that attract I. duplicatus beetles and took bark samples from bark beetle-infested trees. Of the 26 traps used during the four years of monitoring, I. duplicatus was found in 16 traps in the central part of Slovenia in 2020. Adult beetles were caught in traps containing both I. typographus and I. duplicatus lures. The identity of this species was confirmed using morphological keys and molecular methods. One to five I. duplicatus beetles were found per trap, totaling 25 specimens. However, we did not confirm any I. duplicatus in samples taken from trees in 2021. We conclude that I. duplicatus is present in Slovenia, but our results suggest that the species is only present locally and that the population is small.
Keywords: biological invasions, forest pests, temperate forests, conifers, damage, forest pest monitoring, confirmation
Published in DiRROS: 05.09.2023; Views: 342; Downloads: 159
.pdf Full text (3,04 MB)
This document has many files! More...

19.
20.
Search done in 0.19 sec.
Back to top